Two phase heat transfer devices based on the miniature version of loop heat pipe (LHP) can provide very promising cooling solutions for the compact electronic devices due to their high heat flux management capability and long distance heat transfer with minimal temperature losses. This paper discusses the effect of the wick properties on the heat transfer characteristics of the miniature LHP. The miniature model of the LHP with disk-shaped evaporator, 10 mm thick and 30 mm disk diameter, was designed using copper containment vessel and water as the working fluid, which is the most acceptable combination in electronic cooling applications. In the investigation, wick structures with different physical properties including thermal conductivity, pore radius, porosity, and permeability and with different structural topology including monoporous or biporous evaporating face were used. It was experimentally observed that copper wicks are able to provide superior thermal performance than nickel wicks, particularly for low to moderate heat loads due to their low heat conducting resistance. With monoporous copper wick, maximum evaporator heat transfer coefficient of and evaporator thermal resistance of were achieved. For monoporous nickel wick, the corresponding values were for and for . Capillary structure with smaller pore size, high porosity, and high permeability showed better heat transfer characteristics due to sufficient capillary pumping capability, low heat leaks from evaporator to compensation chamber and larger surface area to volume ratio for heat exchange. In addition to this, biporous copper wick structure showed much higher heat transfer coefficient of than monoporous copper wick due to improved evaporative heat transfer at wick wall interface and separated liquid and vapor flow pores. The present work was able to classify the importance of the wick properties in the improvement of the thermal characteristics for miniature loop heat pipes.
Skip Nav Destination
e-mail: randeep.singh@rmit.edu.au
Article navigation
Research Papers
Effect of Wick Characteristics on the Thermal Performance of the Miniature Loop Heat Pipe
Randeep Singh,
Randeep Singh
Energy Conservation and Renewable Energy Group, School of Aerospace, Mechanical and Manufacturing Engineering,
e-mail: randeep.singh@rmit.edu.au
RMIT University
, P.O. Box 71, Bundoora East Campus, Bundoora, Victoria 3083, Australia
Search for other works by this author on:
Aliakbar Akbarzadeh,
Aliakbar Akbarzadeh
Energy Conservation and Renewable Energy Group, School of Aerospace, Mechanical and Manufacturing Engineering,
RMIT University
, P.O. Box 71, Bundoora East Campus, Bundoora, Victoria 3083, Australia
Search for other works by this author on:
Masataka Mochizuki
Masataka Mochizuki
R&D Department, Thermal Technology Division,
Fujikura Ltd.
, 1-5-1 Kiba, Koto-Ku, Tokyo 135-8512, Japan
Search for other works by this author on:
Randeep Singh
Energy Conservation and Renewable Energy Group, School of Aerospace, Mechanical and Manufacturing Engineering,
RMIT University
, P.O. Box 71, Bundoora East Campus, Bundoora, Victoria 3083, Australiae-mail: randeep.singh@rmit.edu.au
Aliakbar Akbarzadeh
Energy Conservation and Renewable Energy Group, School of Aerospace, Mechanical and Manufacturing Engineering,
RMIT University
, P.O. Box 71, Bundoora East Campus, Bundoora, Victoria 3083, Australia
Masataka Mochizuki
R&D Department, Thermal Technology Division,
Fujikura Ltd.
, 1-5-1 Kiba, Koto-Ku, Tokyo 135-8512, JapanJ. Heat Transfer. Aug 2009, 131(8): 082601 (10 pages)
Published Online: June 4, 2009
Article history
Received:
August 4, 2008
Revised:
February 14, 2009
Published:
June 4, 2009
Citation
Singh, R., Akbarzadeh, A., and Mochizuki, M. (June 4, 2009). "Effect of Wick Characteristics on the Thermal Performance of the Miniature Loop Heat Pipe." ASME. J. Heat Transfer. August 2009; 131(8): 082601. https://doi.org/10.1115/1.3109994
Download citation file:
Get Email Alerts
Cited By
Entropic Analysis of the Maximum Output Power of Thermoradiative Cells
J. Heat Mass Transfer
Molecular Dynamics Simulations in Nanoscale Heat Transfer: A Mini Review
J. Heat Mass Transfer
Related Articles
Novel Design of a Miniature Loop Heat Pipe Evaporator for Electronic Cooling
J. Heat Transfer (October,2007)
Direct Simulation of Thermal Transport Through Sintered Wick Microstructures
J. Heat Transfer (January,2012)
Experimental Study on Preparation and Heat Transfer of Nickel-Based Ammonia Loop Heat Pipe
J. Heat Transfer (November,2021)
A Simplified Conduction Based Modeling Scheme for Design Sensitivity Study of Thermal Solution Utilizing Heat Pipe and Vapor Chamber Technology
J. Electron. Packag (September,2003)
Related Chapters
Completing the Picture
Air Engines: The History, Science, and Reality of the Perfect Engine
The Special Characteristics of Closed-Cycle Gas Turbines
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Control and Operational Performance
Closed-Cycle Gas Turbines: Operating Experience and Future Potential