The time-dependent temperature distribution on an inclined, thin-foil uniform-heat-generation heater was used to infer the heat transfer enhancement caused by the passage of an FC-87 bubble sliding beneath the lower surface of the heater. A two-camera system was used: One camera recorded color images of a liquid crystal layer applied to the upper (dry) side of the heater while a second camera simultaneously recorded the position, size, and shape of the bubble from below. The temperature response of the heater could then be correlated directly to the bubble characteristics at any given time during its passage. The data along the line bisecting the bubble wake from the nine bubbles comprising 54 bubble images were analyzed. The heat transfer in the wake behind the sliding cap-shaped bubbles is very effective compared with the natural convection that occurs before the passage of the bubble. The maximum values of heat transfer coefficient in the range of 2500W/m2K were produced in very sharply peaked curves. The point of maximum cooling measured as a fraction of the local driving temperature difference before the bubble passage was identified and correlated with some success to the streamwise length of the bubble. The location of the maximum heat transfer coefficient was reasonably correlated with bubble width. The level of the maximum heat transfer coefficient when cast as a Nusselt number based on bubble width grew to a saturation value as the bubble moved across the plate. A constant value of Nusselt number requires that the heat transfer coefficient falls as the bubble grows past some critical bubble size. This behavior was observed for the larger cap-shaped bubbles.

1.
Cornwell
,
K.
, and
Schuller
,
R. B.
, 1982, “
A Study of Boiling Outside a Tube Bundle Using High Speed Photography
,”
Int. J. Heat Mass Transfer
0017-9310,
25
(
5
), pp.
683
690
.
2.
Cornwell
,
K.
, 1991, “
The Influence of Bubbly Flow on Boiling From a Tube Bundle
,”
Int. J. Heat Mass Transfer
0017-9310,
33
, pp.
2579
2584
.
3.
Klausner
,
J.
, 2000, “
Bubble Forces and Detachment Models
,” Keynote Address,
Engineering Foundation Conference Boiling 2000: Phenomena and Emerging Applications
,
Begell House
,
Reading, CT
.
4.
Cooper
,
M. G.
, and
Lloyd
,
A. J. P.
, 1969, “
The Microlayer in Nucleate Pool Boiling
,”
Int. J. Heat Mass Transfer
0017-9310,
12
, pp.
895
913
.
5.
Koffman
,
L. D.
, and
Plesset
,
M. S.
, 1983, “
Experimental Observations of the Microlayer in Vapor Bubble Growth on a Heated Solid
,”
ASME J. Heat Transfer
0022-1481,
105
, pp.
625
632
.
6.
Addlesee
,
A. J.
,
Cornwell
,
K.
, and
Peace
,
D. G.
, 1989, “
Fluid Dynamics of Sliding Bubbles and Heat Transfer Implications
,”
Pool Boiling, Proceedings of Eurotherm Seminar 8
, , Paderborn, Germany, pp.
57
64
.
7.
Addlesee
,
A. J.
, and
Cornwell
,
K.
, 1997, “
Liquid Film Thickness Above a Bubble Rising Under an Inclined Plate
,”
Chem. Eng. Res. Des.
0263-8762,
75
, pp.
663
667
.
8.
Addlesee
,
A. J.
, and
Cornwell
,
K.
, 1999, “
The Velocity of Bubbles Rising Under an Inclined Plate
,”
Transactions of the ImechE Conference, 6th UK National Conference on Heat Transfer
, pp.
231
236
.
9.
Yan
,
Y.
, and
Kenning
,
D. B. R.
, 1994, “
Heat Transfer Near Sliding Vapour Bubbles in Boiling
,”
Proceedings of the 10th International Heat Transfer Conference
, pp.
195
200
.
10.
Yan
,
Y.
,
Kenning
,
D. B. R.
,
Grant
,
I. A.
, and
Cornwell
,
K.
, 1996, “
Heat Transfer to Sliding Bubbles Under Plane and Curved Surfaces
,”
4th UK National Conference on Heat Transfer
, Manchester, UK, Paper No. IMechE C510/118, pp.
295
299
.
11.
Kenning
,
D. B. R.
,
Bustnes
,
O. E.
, and
Yan
,
Y.
, 2000, “
Heat Transfer to a Sliding Vapor Bubble
,”
Proceedings of ASME Boiling 2000 Conference
, Vol.
104
, pp.
82
89
.
12.
Kenning
,
D. B. R.
, and
Bustnes
,
O. E.
, 2009, “
Liquid Crystal Studies of Sliding Vapour Bubbles
,”
Heat Mass Transfer
0947-7411,
45
(
7
), pp.
867
880
.
13.
Bayazit
,
B. B.
, 2000, “
A Thermographic Analysis of the Heat Transfer Mechanisms Generated by a Sliding Bubble
,” MS thesis, University of Houston, Houston TX.
14.
Bayazit
,
B. B.
,
Hollingsworth
,
D. K.
, and
Witte
,
L. C.
, 2003, “
Heat Transfer Enhancement Caused by Sliding Bubbles
,”
ASME J. Heat Transfer
0022-1481,
125
(
3
), pp.
503
509
.
15.
Qui
,
D.
, and
Dhir
,
V. K.
, 2002, “
Experimental Study of Flow Pattern and Heat Transfer Associated With a Bubble Sliding on Downward Facing Inclined Surfaces
,”
Exp. Therm. Fluid Sci.
0894-1777,
26
, pp.
605
616
.
16.
Thorncroft
,
G. E.
, and
Klausner
,
J. F.
, 1999, “
The Influence of Vapor-Bubble Sliding on Forced Convection Boiling Heat Transfer
,”
ASME J. Heat Transfer
0022-1481,
121
, pp.
73
79
.
17.
Figueroa
,
M.
, 2005, “
The Evolution of the Microlayer Thickness Above a Sliding, Vapor Bubble
,” MS thesis, University of Houston, Houston TX.
18.
Hay
,
J. L.
, and
Hollingsworth
,
D. K.
, 1996, “
A Comparison of Trichromic Systems for Use in the Calibration of Polymer-Dispersed Thermochromic Liquid Crystals
,”
Exp. Therm. Fluid Sci.
0894-1777,
12
, pp.
1
12
.
19.
Hay
,
J. L.
, and
Hollingsworth
,
D. K.
, 1998, “
Calibration of Micro-Encapsulated Liquid Crystals Using Hue Angle and a Dimensionless Temperature
,”
Exp. Therm. Fluid Sci.
0894-1777,
18
, pp.
251
257
.
20.
Dukle
,
N. M.
, and
Hollingsworth
,
D. K.
, 1996, “
Liquid Crystal Images of the Transition From Jet-Impingement Convection to Nucleate Boiling, Part 1: Monotonic Distribution of the Convection Coefficient
,”
Exp. Therm. Fluid Sci.
0894-1777,
12
, pp.
274
287
.
21.
Dukle
,
N. M.
, and
Hollingsworth
,
D. K.
, 1996, “
Liquid Crystal Images of the Transition From Jet-Impingement Convection to Nucleate Boiling, Part 2: Nonmonotonic Distribution of the Convection Coefficient
,”
Exp. Therm. Fluid Sci.
0894-1777,
12
, pp.
288
297
.
22.
Dalrymple
,
N. E.
,
Dukle
,
N. M.
, and
Hollingsworth
,
D. K.
, 1995, “
The Behavior of a Boiling Front in Jet-Impingement Boiling
,”
Proceedings of ASME/JSME Thermal Engineering Conference
, Vol.
2
, pp.
339
346
.
23.
Kays
,
W. M.
,
Crawford
,
M. E.
, and
Weigand
,
B.
, 1994,
Convective Heat and Mass Transfer
,
4th ed.
,
McGraw-Hill
,
New York
.
24.
Li
,
X.
,
Hollingsworth
,
D. K.
, and
Witte
,
L. C.
, 2006, “
The Thickness of the Liquid Microlayer Between a Cap-Shaped Sliding Bubble and a Heated Wall: Experimental Measurements
,”
ASME J. Heat Trans
,
128
, pp.
934
944
.
You do not currently have access to this content.