This paper presents a study of pressure drops during condensation inside a smooth, an 18-deg helical microfin, and a herringbone microfin tube. Measurements were conducted with refrigerant flowing through the tube of a concentric heat exchanger, with water flowing in a counterflow direction in the annulus. Each tube was part of a condenser consisting of eight subcondensers with instrumentation preceding each subcondenser. Three refrigerants were used, namely, R-22, R-407C, and R-134a, all operating at a saturation temperature of with mass fluxes ranging from 400 to Inlet qualities ranged from 0.85 to 0.95 and outlet qualities ranged from 0.05 to 0.15. The test results showed that on average for the three refrigerants the pressure gradients of the herringbone microfin tube were about 79% higher than that of the smooth tube and about 27% higher than that of the helical microfin tube. Further, a correlation from the literature for predicting pressure drops inside a helical microfin tube was modified for the herringbone microfin tube. The modified correlation predicted the data to within an error of 1% and had an absolute mean deviation of 6.8%. This modified correlation compared well with a correlation from the literature that predicted the data to within an error of 7%.
Skip Nav Destination
e-mail: jonathan.olivier@up.ac.za
e-mail: lieb@up.ac.za
e-mail: jmeyer@up.ac.za
Article navigation
Technical Papers
Pressure Drop During Refrigerant Condensation Inside Horizontal Smooth, Helical Microfin, and Herringbone Microfin Tubes
Jonathan A. Olivier,
e-mail: jonathan.olivier@up.ac.za
Jonathan A. Olivier
Department of Mechanical and Aeronautical Engineering, University of Pretoria, Pretoria, 0002, South Africa
Search for other works by this author on:
Leon Liebenberg,
e-mail: lieb@up.ac.za
Leon Liebenberg
Department of Mechanical and Aeronautical Engineering, University of Pretoria, Pretoria, 0002, South Africa
Search for other works by this author on:
Josua P. Meyer
e-mail: jmeyer@up.ac.za
Josua P. Meyer
Department of Mechanical and Aeronautical Engineering, University of Pretoria, Pretoria, 0002, South Africa
Search for other works by this author on:
Jonathan A. Olivier
Department of Mechanical and Aeronautical Engineering, University of Pretoria, Pretoria, 0002, South Africa
e-mail: jonathan.olivier@up.ac.za
Leon Liebenberg
Department of Mechanical and Aeronautical Engineering, University of Pretoria, Pretoria, 0002, South Africa
e-mail: lieb@up.ac.za
Mark A. Kedzierski
Josua P. Meyer
Department of Mechanical and Aeronautical Engineering, University of Pretoria, Pretoria, 0002, South Africa
e-mail: jmeyer@up.ac.za
Contributed by the Heat Transfer Division for publication in the JOURNAL OF HEAT TRANSFER. Manuscript received by the Heat Transfer Division November 19, 2003; revision received June 15, 2004. Associate Editor: M. Jensen.
J. Heat Transfer. Oct 2004, 126(5): 687-696 (10 pages)
Published Online: November 16, 2004
Article history
Received:
November 19, 2003
Revised:
June 15, 2004
Online:
November 16, 2004
Connected Content
Citation
Olivier, J. A., Liebenberg, L., Kedzierski, M. A., and Meyer, J. P. (November 16, 2004). "Pressure Drop During Refrigerant Condensation Inside Horizontal Smooth, Helical Microfin, and Herringbone Microfin Tubes ." ASME. J. Heat Transfer. October 2004; 126(5): 687–696. https://doi.org/10.1115/1.1795240
Download citation file:
Get Email Alerts
Cited By
Related Articles
Discussion “Pressure Drop During Refrigerant Condensation Inside Horizontal Smooth, Helical Microfin, and Herringbone Microfin Tubes” ( Olivier, J. A., Liebenberg, L., Kedzierski, M. A., and Meyer, J. P., 2004, J. Heat Transfer, 126(5), pp. 687–696 )
J. Heat Transfer (January,2008)
Representative Results for Condensation Measurements at Hydraulic Diameters ∼ 100 Microns
J. Heat Transfer (April,2010)
Modeling of Pressure Drop During Condensation in Circular and Noncircular Microchannels
J. Fluids Eng (January,2009)
Heat Transfer Performance During Condensation Inside Spiralled Micro-Fin Tubes
J. Heat Transfer (June,2004)
Related Proceedings Papers
Related Chapters
Condensation in Cool Roofs—Code Challenges, Field Observations, and Hygrothermal Modeling
Roofing Research and Standards Development: 10th Volume
Evaluation of Moisture Accumulation in Composite Roof Decks in High Humidity Environments such as Natatoriums in Cold Climates Using Hygrothermal Modeling
Roofing Research and Standards Development: 10th Volume
Techniques to Reduce Exchanger or System Cost
Heat Exchanger Engineering Techniques