An analysis capability to examine the two-phase bubbly flow in high pressure boiling systems has been developed. The models have been adapted from the literature for a narrow high aspect ratio geometry using the measurements obtained in a companion paper. Three-dimensional computational results have been compared with cross-section averaged and line-averaged void fractions measured with a gamma densitometer, and local void fraction measured with a hot-film anemometer. These comparisons have been made over a wide range of flow inlet conditions, wall heating and system pressure. Comparisons are found to be good when the flow is bubbly, but at high void fractions, where the flow is churn-turbulent or annular, the two-field modeling approach does not perform adequately. This result emphasizes the need for multiple field modeling.
Modeling and Numerical Prediction of Flow Boiling in a Thin Geometry
Contributed by the Heat Transfer Division for publication in the JOURNAL OF HEAT TRANSFER. Manuscript received by the Heat Transfer Division November 20, 2002; revision received October 16, 2003. Associate Editor: D. B. R. Kenning.
- Views Icon Views
- Share Icon Share
- Cite Icon Cite
- Search Site
Kumar, R., Maneri , C. C., and Strayer, T. D. (March 10, 2004). "Modeling and Numerical Prediction of Flow Boiling in a Thin Geometry ." ASME. J. Heat Transfer. February 2004; 126(1): 22–33. https://doi.org/10.1115/1.1643754
Download citation file:
- Ris (Zotero)
- Reference Manager