A theoretical analysis and an experimental investigation were carried out for predicting the critical heat flux (CHF) of convective boiling for a round saturated water jet impinging on the jet stagnation zone. The model of the maximum liquid subfilm thickness based on the Helmholtz instability is used to derive a semi-theoretical equation and the correlation factor was determined from the experimental data. Finally, a semi-theoretical correlation was proposed for predicting CHF of convective boiling for saturated water jet impinging on the jet stagnation zone.
Issue Section:
Evaporation, Boiling, and Condensation
Keywords:
convection,
boiling,
jets,
two-phase flow,
Boiling,
Evaporation,
Forced Convection,
Heat Transfer,
Jets
1.
Monde
, M.
, and Kotto
, Y.
, 1978
, “Burnout in a High Heat-Flux Boiling System with an Impinging Jet
,” Int. J. Heat Mass Transf.
, 21
, pp. 295
–305
.2.
Katto
, Y.
, and Shimizu
, M.
, 1979
, “Upper Limit of CHF in the Saturated Forced Convection Boiling on a Heated Disk with a Small Impinging Jet
,” ASME Heat Transfer
, 101
, pp. 265
–269
.3.
Monde
, M.
, 1980
, “Burnout Heat Flux in Saturated Forced Convection Boiling with an Impinging Jet
,” Heat Transfer-Jpn. Res.
, 9
, pp. 31
–41
.4.
Monde
, M.
, and Okuma
, Y.
, 1985
, “Critical Heat Flux of Saturated Forced Convection Boiling on a Heated Disk with an Impinging Jet-CHF in L-regime
,” Int. J. Heat Mass Transf.
, 28
, pp. 547
–552
.5.
Monde
, M.
, 1987
, “Critical Heat Flux of Saturated Forced Convection Boiling on a Heated Disk with an Impinging Jet
,” ASME J. Heat Transfer
, 109
, pp. 991
–996
.6.
Katto, Y. 1985, “Critical Heat Flux,” Advances in Heat Transfer, J. P. Harnett and T. F. Irvine, Jr., eds., 17, Orland, pp. 20–35.
7.
Sharan
, A.
, and Lienhard
, J. H.
, 1985
, “On Predicting Boiling Burnout in the Jet-Disk Configuration
,” ASME J. Heat Transfer
, 107
, pp. 398
–401
.8.
Katto
, Y.
, and Yokoya
, S.
, 1988
, “Critical Heat Flux on a Disk Heater Cooling by a Circular Jet of Saturated Liquid Impinging at the Center
,” Int. J. Heat Mass Transf.
31
, pp. 219
–227
.9.
Monde
, M.
, and Inoue
, T.
, 1991
, “Critical Heat Flux in Saturated Forced Convection Boiling on a Heated Disk with Multiple Impinging Jets
,” ASME J. Heat Transfer
, 113
, pp. 722
–727
.10.
Monde
, M.
, 1991
, “Critical Heat Flux in Saturated Forced Convection Boiling on a Heated Disk with One or Multiple Impinging Jets
,” Trends in Heat Mass and Momentum Transfer
,1
, pp. 33
–44
.11.
Monde
, M.
, Kitajima
, K.
, Inoue
, T.
, and Mitsutaka
, Y.
, 1994
, “Critical Heat Flux in a Convection Subcooled Boiling with an Impinging Jet
,” ASME J. Heat Transfer
, 7
, pp. 512
–518
.12.
Monde
, M.
, and Mitsutake
, Y.
, 1996
, “Critical Heat Flux in a Convection Subcooled Boiling with Multiple Impinging Jets
,” ASME J. Heat Transfer
, 117
, pp. 241
–243
.13.
Zuber, N., 1959, “Hydrodynamic Aspects of Boiling Heat Transfer,” AEC Report No. AECU-4439.
14.
Haramura
, Y.
, and Katto
, Y.
, 1983
, “A New Hydrodynamic Model of Critical Heat Flux, Applicable Widely to Both Pool and Forced Convection Boiling on Submerged Bodies in Saturated Liquids
,” Int. J. Heat Mass Transf.
, 26
, pp. 389
–399
.15.
Mudawar
, I. A.
, Incroea
, T. A.
, and Incropera
, F. P.
, 1987
, “Boiling Heat Transfer and Critical Heat Flux in Liquid Films Falling on Vertically-Mounted Heat Sources
,” Int. J. Heat Mass Transf.
, 30
, pp. 2083
–2095
.16.
Ueda
, T.
, Inoue
, M.
, and Nagatome
, S.
, 1981
, “Critical Heat Flux and Droplet Entrapment Rate in Boiling of Falling Liquid Films
,” Int. J. Heat Mass Transf.
, 24
, pp. 1257
–1266
.17.
Baines
, R. P.
, El-Masri
, M. A.
, and Rohsenow
, W. M.
, 1984
, “Critical Heat Flux in Flowing Liquid Films
,” Int. J. Heat Mass Transf.
, 27
, pp. 1623
–1629
.18.
Katto
, Y.
, Yokoya
, S.
, Miake
, S.
, and Taniguchi
, M.
, 1987
, “Critical Heat Flux on a Uniformly Heated Cylinder in a Cross Flow of Saturated Liquid Over a Very Wide Range of Vapor to Liquid Density Ratio
,” Int. J. Heat Mass Transf.
, 30
, pp. 1971
–1977
.19.
Liu
, W.
, Nariai
, H.
, and Inasaka
, F.
, 2000
, “Prediction of Critical Heat Flux for Subcooling Boiling
,” Int. J. Heat Mass Transf.
, 43
, pp. 3371
–3390
.20.
Ishigami, S. K., Nakamishi, J. K., and Hikoshichi, T. A., 1978, “Boiling Heat Transfer for a Plane Water Jet Impinging on a Hot Surface,” Proceedings of the 6th International Heat Transfer Conference, Hemisphere Publishing Corp., Washington, DC, 1, pp. 445–450.
21.
Nakamishi
, J. K.
, Ishigami
, S. K.
, Ochi
, T.
, and Morita
, I.
, 1980
, “Two-Dimensional Water Jet Impinging for Cooling of High Temperature Plate
,” Bull. JSME
, 46
, pp. 714
–724
.22.
Zhe
, J.
, Sun
, H.
, Ma
, C. F.
, Lei
, D.
, He
, C.
, and Tian
, Y.
, 1997
, “Experimental Study on Heat Transfer of Water Jet and Spraying Cooling High Temperature Wall
,” Chinese Journal of Engineering Thermophsics
,18
, pp. 629
–633
.23.
Liu
, H.
, and Wang
, J.
, 2001
, “Study on Film Boiling Heat Transfer for Water Jet Impinging on a High Temperature Flat Plate
,” Int. J. Heat Mass Transf.
, 44
, pp. 2475
–2481
.24.
Kumagai
, S.
, Sano
, T.
, Kamata
, T.
, Suzuki
, S.
, and Kubo
, R.
, 1994
, “Boiling Heat Transfer to an Impinging Jet in Cooling a Hot Metal Slab
,” Bulletin of JASM (B)
,60
, pp. 259
–263
.25.
Kumagai
, S.
, Sano
, T.
, Kamata
, T.
, Suzuki
, S.
, and Kubo
, R.
, 1995
, “Transient Cooling of Hot Plate with Impinging Water Jet
,” Bulletin of JASM (B)
,61
, pp. 351
–356
.26.
Ma
, C. F.
, and Bergles
, A. E.
, 1986
, “Jet Impinging Nucleate Boiling
,” Int. J. Heat Mass Transf.
, 29
, pp. 1095
–1101
.27.
Miyazaki
, H.
, and Siberman
, E.
, 1972
, “Flow and Heat Transfer on a Flat Plate with a Two-Dimensional Laminar Jet Issuing from a Nozzle of Finite Height
,” Int. J. Heat Mass Transf.
, 15
, pp. 2097
–2107
.28.
Stephan
, K.
, and Abdelsalam
, M.
, 1980
. “Heat Transfer Correlations for Natural Convection Boiling
,” Int. J. Heat Mass Transfer
, 23
, pp. 73
–81
.Copyright © 2002
by ASME
You do not currently have access to this content.
