Performance characteristics are experimentally determined for enhanced convective boiling of FC-87 in a horizontal, small-cross-sectional-area, single-channel heater. The channel tested has a square cross section with a side length of 2 mm and a heated length of 8 cm. The heated surface of the channel is tested both with, and without, a microporous surface coating. Although few studies have been performed to quantify the effects of internal porous coatings on flow boiling, their application in this area is promising. The coating is shown to provide increases in both heat transfer coefficient and critical heat flux. Convective boiling curves are generated for mass fluxes from 500 to 5000 kg/m2s and for inlet subcooling levels ranging from 2 to 31°C.
Enhancing Small-Channel Convective Boiling Performance Using a Microporous Surface Coating
Contributed by the Heat Transfer Division for publication in the JOURNAL OF HEAT TRANSFER. Manuscript received by the Heat Transfer Division November 8, 1999; revision received February 12, 2001. Associate Editor: C. Beckermann.
- Views Icon Views
- Share Icon Share
- Search Site
Ammerman, C. N., and You, S. M. (February 12, 2001). "Enhancing Small-Channel Convective Boiling Performance Using a Microporous Surface Coating ." ASME. J. Heat Transfer. October 2001; 123(5): 976–983. https://doi.org/10.1115/1.1388300
Download citation file: