The present paper reports on the results of a series of authors’ parabolic flight experiments on spray cooling in addition to ground-based experiments in which the influence of heater orientation and the behavior of rebounded droplets were especially studied in detail. Water and FC-72 (perfluorocarbon) were employed alternatively as a test liquid sprayed from a single full-cone nozzle onto a Cr-plated surface of an electrically heated copper block for transient cooling experiments or onto a transparent ITO (indium tin oxide) coated surface of a glass block for steady state experiments in a relatively low superheat region. Each experimental run was accomplished within some 15 sec through which a stable reduced gravity condition (0.01 times the terrestrial gravity) was maintained in the aircraft. Cooling curves were obtained over a wide range of each of the following parameters: the wall superheat, the spray volume flux and the Weber number for the spray droplets. It is demonstrated that the gravity dependency of the spray cooling characteristics varies with the spray volume flux and the droplet Weber number. Qualitative interpretations of the observed gravity dependency are provided.
Spray Cooling Under Reduced Gravity Condition
Contributed by the Heat Transfer Division for publication in the JOURNAL OF HEAT TRANSFER. Manuscript received by the Heat Transfer Division February 3, 2000; revision received July 19, 2000. Associate Editor: T. Avedisian.
- Views Icon Views
- Share Icon Share
- Cite Icon Cite
- Search Site
Yoshida, K., Abe, Y., Oka, T., Mori , Y. H., and Nagashima, A. (July 19, 2000). "Spray Cooling Under Reduced Gravity Condition ." ASME. J. Heat Transfer. April 2001; 123(2): 309–318. https://doi.org/10.1115/1.1345887
Download citation file:
- Ris (Zotero)
- Reference Manager