High Flux Boiling in Low Flow Rate, Low Pressure Drop Mini-Channel and Micro-Channel Heat Sinks,”
International Journal of Heat and Mass Transfer, Vol.
Cao, Y., Beam, J. E., and Donovan, B., 1996, “Air-Cooling System for Metal Oxide Semiconductor Controlled Thyristors Employing Miniature Heat Pipes,” Journal of Thermophysics and Heat Transfer, Vol. 10, No. 3, July-Sept.
Hopkins, R., 1996, “Flat Miniature Heat Sinks and Heat Pipes with Micro Capillary Grooves: Manufacturing, Modeling and Experimental Study,” Masters thesis, The University of Connecticut, Storrs, CT.
Hopkins, R., Faghri, A., and Khrustalev, D., 1997, “Critical Heat Fluxes and Pressure Drops in Flat Miniature Heat Sinks with Micro Capillary Grooves,” 1997 National Heat Transfer conference, Baltimore, MD, HTD-Vol. 349, pp. 61–70.
Jacobs, H. R., and Hartnett, J. P., 1991, “Thermal Engineering: Emerging Technologies and Critical Phenomena,” Workshop Report, NSF Grant No. CTS-91-04006, pp. 139–176.
A Generalized Correlation of Critical Heat Flux for the Forced Convection Boiling in Vertical Uniformly Heated Round Tubes,”
Int. J. Heat Mass Transfer, Vol.
Khrustalev, D., and Faghri, A., 1995, “Boiling Heat Transfer in the Miniature Axially-Grooved Rectangular Channel with Discrete Heat Sources,” Proceedings of the 30th National Heat Transfer Conference, HTD-Vol. 305, pp. 165–174.
Peng, X. F., and Wang, B. X., 1994, “Liquid Flow and Heat Transfer in Micro-channels With/Without Phase Change,” Proc. of the 10th International Heat Transfer Conf., Brighton, UK, Vol. 1, pp. 159–177.
Ravigururajan, T. S., Cuta, J., McDonald, C. E., and Drost, M. K., 1996, “Effects of Heat Flux on Two-Phase Flow Characteristics of Refrigerant Flows in a Micro-Channel Heat Exchanger,” Proc. of the 31st National Heat Transfer Conference, Houston, TX, HTD-Vol. 329, Vol. 7, pp. 167–178.
Microchannel Heat Sink Based on Boiling Heat Transfer,”
Journal of the Japan Society of Mechanical Engineers (B), Vol.
This content is only available via PDF.
Copyright © 1999
by The American Society of Mechanical Engineers