The effects of solid conductive blocks on the initiation of convection in a porous medium are reported in this paper. A two-dimensional convective code was used to determine the temperature field, the structure of the motion, and the global heat transfer through a composite medium consisting of permeable and impermeable areas. Influence of the size of impermeable regions on convection as well as the effect of the distance between these solid blocks was studied in terms of Nusselt number and maximum of the stream function. The predicted heat transfer in this type of composite medium, obtained with the code, was compared with experimental results where the porous medium is a low-density insulating material in which some wood joists are included. This configuration corresponds to the layer of insulation on the floor of a residential attic.

Issue Section:
Heat Transfer in Porous Media
Keywords:
Modeling and Scaling, Natural Convection, Porous Media
Topics:
Natural convection, Porous materials, Composite materials, Convection, Heat transfer, Insulation, Density, Joists, Modeling, Temperature, Wood products
1.
Arquis, E., and Caltagirone, J. P., 1987, “Interacting Convection Between Fluid and Open Porous Layer,” presented at the ASME Winter Annual Meeting, Boston, MA, Dec. 13–18.
2.
Bankvall, C. G., 1975, “Mechanism of Heat Transfer in Permeable Insulation and Their Investigation in Special Guarded Hot Plate,” Heat Transmission Measurements in Thermal Insulation, ASTM STP 554, American Society for Testing and Material, Philadelphia, PA, pp. 34–38.
3.
Beckwith, J., 1991, “Air Permeability,” Internal report, Certain Teed Corporation.
4.
Delmas, A., and Wilkes, K. E., 1992a, “Numerical Analysis of Heat Transfer by Conduction and Natural Convection in Loose Fill Fiberglass Insulation—Effects of Convection on Thermal Performance,” ORNL/CON-338, Oak Ridge National Laboratory, Oak Ridge, TN.
5.
Delmas, A., and Wilkes, K. E., 1992b, “Calculation of Thermal Resistance of Some Loose Fill Insulation When Natural Convection Occurs Within the Insulating Material—Comparison With Experimental Data,” ORNL/CON-348, Oak Ridge National Laboratory, Oak Ridge, TN.
6.
Fournier, D., and Klarsfeld, S., 1971, “Utilisation d’un Appareil Orientable a` Plaque chaude Garde´e pour la Mise en Evidence du Transfert de Chaleur par Convection Naturelle on Milieu Poreux dans des Conditions Simule´es,” Proceedings, 13th International Congress of Refrigeration, W. T. Pentzer et al., eds., Washington, Vol. 2, pp. 53–61.
7.
Langlais, C., Arquis, E., and McCaa, D. J., 1990, “A Theoretical and Experimental Study of Convective Effects in Loose Fill Thermal Insulation,” Insulation Material Testing and Applications, ASTM STP 1030, American Society for Testing and Material, Philadelphia, PA, pp. 290–310.
8.
Nield
D. A.
,
1968
, “
Onset of Thermohaline Convection in Porous Medium
,”
Water Resour. Res.
, Vol.
4
, pp.
553
–
560
.
9.
Silberstein
A.
,
Langlais
C.
, and
Arquis
E.
,
1990
, “
Natural Convection in Light Fibrous Insulating Materials With Permeable Interface: Onset Criteria and Its Effects on the Thermal Performances of the Product
,”
J. Therm. Insul.
, Vol.
14
, pp.
22
–
42
.
10.
Wilkes
K. E.
, and
Rucker
J. L.
,
1983
, “
Thermal Performance of Residential Attic Insulation
,”
Energy and Buildings
, Vol.
5
, pp.
263
–
277
.
11.
Wilkes, K. E., Wendt, R. L., Delmas, A., and Childs, P. W., 1991a, “Attic Testing at the Roof Research Center—Initial Results,” Proceedings, The International Symposium on Roofing Technology, National Roofing Contractors Association, Rosemont, IL.
12.
Wilkes, K. E., Wendt, R. L., Delmas, A., and Childs, P. W., 1991b, “Thermal Performance of One Loose-Fill Fiberglass Attic Insulation,” Insulation Materials: Testing and Applications, ASTM STP 1116, R. S. Graves and D. C. Wysocki, eds., American Society for Testing and Materials, Philadelphia, PA, Vol. 2, pp. 275–291.
13.
Wilkes, K. E., and Childs, P. W., 1992, “Thermal Performance of Fiberglass and Cellulose Attic Insulations,” Thermal Performance of the Exterior Envelopes of Buildings V, Proceedings of the ASHRAE/DOE/BTECC Conference, American Society of Heating and Air-Conditioning Engineers, Clearwater, FL.
14.
Wilkes, K. E., and Graves, R. S., 1993, “Air-Flow Permeability of Attic Insulation Materials,” ORNL/M. 2646, Oak Ridge National Laboratory, Oak Ridge, TN.
15.
Yarbrough, D., 1991, “Reduction in the Thermal Resistance (R-Value) of Loose-Fill Insulation and Fiberglass Batts Due to Compression,” ORNL/Sub-7715/2, Oak Ridge, TN.
This content is only available via PDF.
Copyright © 1995
 by The American Society of Mechanical Engineers
You do not currently have access to this content.