Heat transfer and particle motion relative to the modified chemical vapor deposition process have been studied for general values of the torch speed. Three-dimensional temperature fields have been obtained over the entire cross section of the tube and the effects of tube rotation and localized torch heating in the axial and circumferential directions have been studied. The particle trajectories have been calculated from a formulation that includes the contributions from forced flow, i.e, Poiseuille flow in the axial direction, rigid body rotation about the tube axis, and thermophoretic contributions in the axial, radial, and angular directions. The particle trajectories are helices and are shown to be strongly dependent on the tube rotation.
Skip Nav Destination
Article navigation
Research Papers
A Study of Heat Transfer and Particle Motion Relative to the Modified Chemical Vapor Deposition Process
M. Choi,
M. Choi
Department of Mechanical Engineering, University of California at Berkeley, Berkeley, CA 94720
Search for other works by this author on:
R. Greif,
R. Greif
Department of Mechanical Engineering, University of California at Berkeley, Berkeley, CA 94720
Search for other works by this author on:
H. R. Baum
H. R. Baum
Center for Fire Research, National Institute of Standards and Technology, Gaithersburg, MD 20899
Search for other works by this author on:
M. Choi
Department of Mechanical Engineering, University of California at Berkeley, Berkeley, CA 94720
R. Greif
Department of Mechanical Engineering, University of California at Berkeley, Berkeley, CA 94720
H. R. Baum
Center for Fire Research, National Institute of Standards and Technology, Gaithersburg, MD 20899
J. Heat Transfer. Nov 1989, 111(4): 1031-1037 (7 pages)
Published Online: November 1, 1989
Article history
Received:
April 6, 1988
Online:
October 20, 2009
Citation
Choi, M., Greif, R., and Baum, H. R. (November 1, 1989). "A Study of Heat Transfer and Particle Motion Relative to the Modified Chemical Vapor Deposition Process." ASME. J. Heat Transfer. November 1989; 111(4): 1031–1037. https://doi.org/10.1115/1.3250764
Download citation file:
Get Email Alerts
Cited By
Entropic Analysis of the Maximum Output Power of Thermoradiative Cells
J. Heat Mass Transfer
Molecular Dynamics Simulations in Nanoscale Heat Transfer: A Mini Review
J. Heat Mass Transfer
Related Articles
A Three-Dimensional Analysis of the Flow and Heat Transfer for the Modified Chemical Vapor Deposition Process Including Buoyancy, Variable Properties, and Tube Rotation
J. Heat Transfer (May,1991)
An Experimental Study of Heat Transfer and Particle Deposition for the Modified Chemical Vapor Deposition
J. Heat Transfer (November,1995)
Modeling Micro Mass and Heat Transfer for Gases Using Extended Continuum Equations
J. Heat Transfer (March,2009)
Rayleigh Light Scattering Measurements of Transient Gas Temperature
in a Rapid Chemical Vapor Deposition Reactor
J. Heat Transfer (February,2000)
Related Proceedings Papers
Related Chapters
Adding Surface While Minimizing Downtime
Heat Exchanger Engineering Techniques
Thermodynamic Performance
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Completing the Picture
Air Engines: The History, Science, and Reality of the Perfect Engine