A two-phase flow high-velocity jet with phase change was studied numerically. The jet is assumed to be created by the two-phase critical flow discharge through a pipe of variable length and attached to a vessel containing the saturated liquid at different stagnation pressures. The jet flow is assumed to be axisymmetric and the modeling of the two-phase flow was accomplished by a nonequilibrium model that accounts for the relative velocity and temperature difference between the phases. The numerical solution of the governing set of balance and conservation equations revealed steep gradients of flow properties in both radial and axial directions. The liquid phase in the jet is shown to remain close to the jet axis, and its velocity increases until it reaches a maximum corresponding to the gas velocity, and thereafter decreases at the same rate as the gas velocity. The effect of decreasing the pipe length is shown to produce a larger disequilibrium in the jet and a double pressure peak in the total pressure distribution. A comparison of the predicted total pressure distribution in the jet with the experimental data of steam–water at different axial locations is demonstrated to be very reasonable.
Skip Nav Destination
Article navigation
November 1988
This article was originally published in
Journal of Heat Transfer
Research Papers
Liquid and Gas-Phase Distributions in a Jet With Phase Change
Flavio Dobran
Flavio Dobran
New York University, Applied Science Department, New York, NY 10003
Search for other works by this author on:
Flavio Dobran
New York University, Applied Science Department, New York, NY 10003
J. Heat Transfer. Nov 1988, 110(4a): 955-960 (6 pages)
Published Online: November 1, 1988
Article history
Received:
February 9, 1987
Online:
October 20, 2009
Citation
Dobran, F. (November 1, 1988). "Liquid and Gas-Phase Distributions in a Jet With Phase Change." ASME. J. Heat Transfer. November 1988; 110(4a): 955–960. https://doi.org/10.1115/1.3250598
Download citation file:
Get Email Alerts
Cited By
Estimation of thermal emission from mixture of CO2 and H2O gases and fly-ash particles
J. Heat Mass Transfer
Non-Classical Heat Transfer and Recent Progress
J. Heat Mass Transfer
Related Articles
Interfacial Heat Transfer Between Steam Bubbles and Subcooled Water in Vertical Upward Flow
J. Heat Transfer (May,1995)
Critical Two-Phase Flow in Pipes for Subcooled Stagnation States With a Cavity Flooding Incipient Flashing Model
J. Heat Transfer (November,1990)
Editorial
J. Fluids Eng (December,2000)
Prediction of the Onset of Significant Void in Flow Boiling of Water
J. Heat Transfer (November,1994)
Related Proceedings Papers
Related Chapters
Multiphase Flow Simulations of Sediment Particles in Mixed-flow Pumps
Mixed-flow Pumps: Modeling, Simulation, and Measurements
PSA Level 2 — NPP Ringhals 2 (PSAM-0156)
Proceedings of the Eighth International Conference on Probabilistic Safety Assessment & Management (PSAM)
Development of Nuclear Boiler and Pressure Vessels in Taiwan
Companion Guide to the ASME Boiler and Pressure Vessel Code, Volume 3, Third Edition