Skip Nav Destination
Article navigation
July 1974
This article was originally published in
Journal of Engineering for Power
Discussions
Closure to “Discussion of ‘Effect of Rotor Design Tip Speed on Aerodynamic Performance of a Model VTOL Lift Fan Under Static and Crossflow Conditions’” (1974, ASME J. Eng. Power, 96, p. 322)
J. Eng. Power. Jul 1974, 96(3): 323 (1 pages)
Published Online: July 1, 1974
Article history
Online:
July 14, 2010
Article
Article discussed|
View article
Connected Content
This is a commentary to:
Arbitrary Pole Placement With Limited Number of Inputs and Outputs
Citation
Stockman, N. O., Loeffler, I. S., and Liebein, S. (July 1, 1974). "Closure to “Discussion of ‘Effect of Rotor Design Tip Speed on Aerodynamic Performance of a Model VTOL Lift Fan Under Static and Crossflow Conditions’” (1974, ASME J. Eng. Power, 96, p. 322)." ASME. J. Eng. Power. July 1974; 96(3): 323. https://doi.org/10.1115/1.3445842
Download citation file:
73
Views
Get Email Alerts
Cited By
Temperature Dependence of Aerated Turbine Lubricating Oil Degradation from a Lab-Scale Test Rig
J. Eng. Gas Turbines Power
Multi-Disciplinary Surrogate-Based Optimization of a Compressor Rotor Blade Considering Ice Impact
J. Eng. Gas Turbines Power
Experimental Investigations on Carbon Segmented Seals With Smooth and Pocketed Pads
J. Eng. Gas Turbines Power
Related Articles
Rotor Profiles Synthesis for Lobe Pumps With Given Flow Rate Functions
J. Mech. Des (March,2005)
Rotordynamic Force Coefficients of Pocket Damper Seals
J. Turbomach (October,2006)
Improving the
Performance of a Turbine With Low Aspect Ratio Stators by
Aft-Loading
J. Turbomach (July,2006)
Related Proceedings Papers
Related Chapters
Introduction
Turbine Aerodynamics: Axial-Flow and Radial-Flow Turbine Design and Analysis
Performance and Mechanical Equipment Standards
Handbook for Cogeneration and Combined Cycle Power Plants, Second Edition
Design of Rotor Time Constant Estimator and Sliding Mode Position Controller for Induction Machines
Proceedings of the 2010 International Conference on Mechanical, Industrial, and Manufacturing Technologies (MIMT 2010)