Skip Nav Destination
Article navigation
October 1966
This article was originally published in
Journal of Engineering for Power
Discussions
Discussion: “A Procedure for Calculating the Stresses in a Centrifugal Impeller With Cover Disk” (Ho, B. P. C., 1966, ASME J. Eng. Power, 88, pp. 395–401)
Thomas Vuksta, Jr.
Thomas Vuksta, Jr.
Engineered Compressors, Allis-Chalmers Mfg. Co., Milwaukee, Wis.
Search for other works by this author on:
Thomas Vuksta, Jr.
Engineered Compressors, Allis-Chalmers Mfg. Co., Milwaukee, Wis.
J. Eng. Power. Oct 1966, 88(4): 401 (1 pages)
Published Online: October 1, 1966
Article history
Online:
January 10, 2012
Connected Content
A commentary has been published:
Discussion: “Effects of Nonsymmetry in Strip Rolling on Single-Roll Drive Mills” (Holbrook, Richard L., and Zorowski, Carl F., 1966, ASME J. Eng. Ind., 88, pp. 401–408)
This is a commentary to:
A Procedure for Calculating the Stresses in a Centrifugal Impeller With Cover Disk
Citation
Vuksta, T., Jr. (October 1, 1966). "Discussion: “A Procedure for Calculating the Stresses in a Centrifugal Impeller With Cover Disk” (Ho, B. P. C., 1966, ASME J. Eng. Power, 88, pp. 395–401)." ASME. J. Eng. Power. October 1966; 88(4): 401. https://doi.org/10.1115/1.3678570
Download citation file:
107
Views
Get Email Alerts
Cited By
Accelerating Chemical Kinetics Calculations with Physics Informed Neural Networks
J. Eng. Gas Turbines Power
Fully Coupled Analysis of Flutter Induced Limit Cycles: Frequency Versus Time Domain Methods
J. Eng. Gas Turbines Power (July 2023)
Impact of Ignition Assistant on Combustion of Cetane 30 and 35 Jet-Fuel Blends in a Compression-Ignition Engine at Moderate Load and Speed
J. Eng. Gas Turbines Power (July 2023)
Related Articles
A Procedure for Calculating the Stresses in a Centrifugal Impeller With Cover Disk
J. Eng. Power (October,1966)
Rotordynamic Performance of an Oil-Free Turbo Blower Focusing on Load Capacity of Gas Foil Thrust Bearings
J. Eng. Gas Turbines Power (February,2012)
A Computational Comparative Study of the Lithium Diffusion in Amorphous Silicon Spheres, Rods, and Circular Disks
J. Electrochem. En. Conv. Stor (February,2021)
Analysis and Validation of a Unified Slip Factor Model for Impellers at Design and Off-Design Conditions
J. Turbomach (October,2011)
Related Proceedings Papers
Related Chapters
Mechanical Construction
Turbo/Supercharger Compressors and Turbines for Aircraft Propulsion in WWII: Theory, History and Practice—Guidance from the Past for Modern Engineers and Students
Introduction
Design of Mechanical Bearings in Cardiac Assist Devices
Hydrodynamic Lubrication
Design of Mechanical Bearings in Cardiac Assist Devices