Subsea pumps and compressors must withstand multiphase flows whose gas volume fraction (GVF) or liquid volume fraction (LVF) varies over a wide range. Gas or liquid content as a dispersed phase in the primary stream affects the leakage, drag torque, and dynamic forced performance of secondary flow components, namely seals, thus affecting the process efficiency and mechanical reliability of pumping/compressing systems, in particular during transient events with sudden changes in gas (or liquid) content. This paper, complementing a parallel experimental program, presents a computational fluid dynamics (CFD) analysis to predict the leakage, drag power, and dynamic force coefficients of a smooth surface, uniform clearance annular seal supplied with air in oil mixture whose inlet GVF varies discretely from 0.0 to 0.9, i.e., from a pure liquid stream to a nearly all-gas content mixture. The test seal has uniform radial clearance Cr = 0.203 mm, diameter D = 127 mm, and length L = 0.36 D. The tests were conducted with an inlet pressure/exit pressure ratio equal to 2.5 and a rotor surface speed of 23.3 m/s (3.5 krpm), similar to conditions in a pump neck wear ring seal. The CFD two-phase flow model, first to be anchored to test data, uses an Euler–Euler formulation and delivers information on the precise evolution of the GVF and the gas and liquid streams' velocity fields. Recreating the test data, the CFD seal mass leakage and drag power decrease steadily as the GVF increases. A multiple-frequency shaft whirl orbit method aids in the calculation of seal reaction force components, and from which dynamic force coefficients, frequency-dependent, follow. For operation with a pure liquid, the CFD results and test data produce a constant cross-coupled stiffness, damping, and added mass coefficients, while also verifying predictive formulas typical of a laminar flow. The injection of air in the oil stream, small or large in gas volume, immediately produces force coefficients that are frequency-dependent; in particular the direct dynamic stiffness which hardens with excitation frequency. The effect is most remarkable for small GVFs, as low as 0.2. The seal test direct damping and cross-coupled dynamic stiffness continuously drop with an increase in GVF. CFD predictions, along with results from a bulk-flow model (BFM), reproduce the test force coefficients with great fidelity. Incidentally, early engineering practice points out to air injection as a remedy to cure persistent (self-excited) vibration problems in vertical pumps, submersible and large size hydraulic. Presently, the model predictions, supported by the test data, demonstrate that even a small content of gas in the liquid stream significantly raises the seal direct stiffness, thus displacing the system critical speed away to safety. The sound speed of a gas in liquid mixture is a small fraction of those speeds for either the pure oil or the gas, hence amplifying the fluid compressibility that produces the stiffness hardening. The CFD model and a dedicated test rig, predictions and test data complementing each other, enable engineered seals for extreme applications.

References

References
1.
Poerner
,
M.
,
Cater
,
R.
,
Nolen
,
C.
,
Musgrove
,
G.
, and
Ranson
,
D.
,
2017
, “
Wet Gas Compression-Characterizing Two-Phase Flow Inside a Compressor With Flow Visualization
,”
ASME
Paper No. GT2017-64541.
2.
Vigdal
,
L. A.
, and
Bakken
,
L. E.
,
2017
, “
Variable Inlet Guide Vane Losses and Their Effect on Downstream Impeller and Diffuser in Wet Gas Flow
,”
ASME
Paper No. GT2017-64783.
3.
Vigdal
,
L. A.
, and
Bakken
,
L. E.
,
2017
, “
The Use of Variable Inlet Guide Vane or Speed Control to Maintain Constant Compressor Pressore Ratio in Wet Gas Flow and Their Effect on Diffuser Stability
,”
ASME
Paper No. GT2017-64785.
4.
Bakken
,
M.
, and
Bjørge
,
T.
,
2017
, “
An Experimental Investigation on the Impact of Inlet Slugging on Wet Gas Compressor Performance
,”
ASME
Paper No. GT2017-65094.
5.
Brenne
,
L.
,
Bjorge
,
T.
, and
Gilarranz
,
J.
,
2005
, “
Performance Evaluation of a Centrifugal Compressor Operating Under Wet Gas Conditions
,”
34th Turbomachinery Symposium
, Houston, TX, Sept. 12–15, pp. 111–120.
6.
Ransom
,
D.
,
Podesta
,
L.
,
Camatti
,
M.
,
Wilcox
,
M.
,
Bertoneri
,
M.
, and
Bigi
,
M.
,
2011
, “
Mechanical Performance of a Two Stage Centrifugal Compressor Under Wet Gas Conditions
,”
40th Turbomachinery Symposium
, Houston, TX, Sept. 12–15, pp. 121–128.
7.
Vannini
,
G.
,
Bertoneri
,
M.
,
Del Vescovo
,
G.
, and
Wilcox
,
M.
,
2014
, “
Centrifugal Compressor Rotordynamics in Wet Gas Conditions
,”
43rd Turbomachinery Symposium
, Houston, TX, Sept. 12–15, pp.
201
220
.http://oaktrust.library.tamu.edu/handle/1969.1/162697
8.
Iwatsubo
,
T.
, and
Nishino
,
T.
,
1993
, “
An Experimental Study on the Static and Dynamic Characteristics of Pump Annular Seals
,”
Seventh Workshop on Rotordynamic Instability Problems in High Performance Turbomachinery
, College Station, TX, May 10–12, pp.
30
45
.
9.
San Andrés
,
L.
,
Lu
,
X.
, and
Liu
,
Q.
,
2016
, “
Measurements of Flow Rate and Force Coefficients in a Short-Length Annular Seal Supplied With a Liquid/Gas Mixture (Stationary Journal)
,”
Tribol. Trans.
,
59
(
4
), pp.
758
767
.
10.
San Andrés
,
L.
, and
Lu
,
X.
,
2018
, “
Leakage, Drag Power and Rotordynamic Force Coefficients of an Air in Oil (Wet) Annular Seal
,”
ASME J. Eng. Gas Turbine Power
,
140
(
1
), p.
012505
.
11.
Lu
,
X.
, and
San Andrés
,
L.
,
2018
, “
Leakage and Rotordynamic Force Coefficients of a Three-Wave (Air in Oil) Wet Annular Seal: Measurements and Predictions
,”
ASME
Paper No. GT2018-75200.
12.
San Andrés
,
L.
,
Lu
,
X.
, and
Zhu
,
J.
,
2018
, “
On the Leakage and Rotordynamic Force Coefficients of Pump Annular Seals Operating With Air/Oil Mixtures: Measurements and Predictions
,”
Second Asia Turbomachinery & Pump Symposium
, Singapore, Mar. 22–25.
13.
Zhang
,
M.
,
James
,
E.
,
Mclean
, Jr.
, and
Childs
,
D.
,
2017
, “
Experimental Study of the Static and Dynamic Characteristics of a Long Smooth Seal With Two-Phase, Mainly-Air Mixtures
,”
ASME J. Eng. Gas Turbines Power
,
139
(
12
), p.
122504
.
14.
Voigt
,
A. J.
,
Mandrum-Polsen
,
C.
,
Nielsen
,
K. K.
, and
Santos
,
I. F.
,
2017
, “
Design and Calibration of a Full Scale Active Magnetic Bearing Based Test Facility for Investigating Rotordynamic Properties of Turbomachinery Seals in Multiphase Flow
,”
ASME J. Eng. Gas Turbines Power
,
139
(
5
), p.
052505
.
15.
San Andrés
,
L.
,
2012
, “
Rotordynamic Force Coefficients of Bubbly Mixture Annular Pressure Seals
,”
ASME J. Eng. Gas Turbines Power
,
134
(
2
), p.
022503
.
16.
Arghir
,
M.
,
Zerarka
,
E.
, and
Pieanu
,
G.
,
2011
, “
Rotordynamic Analysis of Textured Annular Seals With Multiphase (Bubbly) Flow
,”
INCAS Bull.
,
3
(
3
), pp.
3
13
.
17.
Vannini
,
G.
,
Bertoneri
,
M.
,
Nielsen
,
K. K.
,
Ludiciani
,
P.
, and
Stronach
,
R.
,
2016
, “
Experimental Results and Computational Fluid Dynamics Simulations of Labyrinth and Pocket Damper Seals for Wet Gas Compression
,”
ASME J. Eng. Gas Turbines Power
,
138
(
5
), p.
052501
.
18.
Voigt
,
A. J.
,
Iudiciani
,
P.
,
Nielsen
,
K. K.
, and
Santos
,
I. F.
,
2016
, “
CFD Applied for the Identification of Stiffness and Damping Properties for Smooth Annular Turbomachinery Seals in Multiphase Flow
,”
ASME
Paper No. GT2016-57905.
19.
Childs
,
D. W.
,
2013
,
Turbomachinery Rotordynamics With Case Studies
,
Minter Spring Publishing
,
Wellborn, TX
, pp.
323
342
.
20.
ANSYS
,
2015
,
ANSYS Fluent User's Guide 15.0
,
ANSYS
Inc.,
Canonsburg, PA
.
21.
Schiller
,
L.
, and
Naumann
,
A.
,
1935
, “
A Drag Coefficient Correlation
,”
Z. Ver. Deutsch Ing.
,
77
, pp.
318
320
.
22.
Li
,
Z.
,
Li
,
J.
, and
Feng
,
Z.
,
2016
, “
Comparisons of Rotordynamic Characteristics Predictions for Annular Gas Seals Using the Transient Computational Fluid Dynamic Method Based on Different Single-Frequency and Multi-Frequency Rotor Whirling Models
,”
ASME J. Tribol.
,
138
(
1
), p.
011701
.
23.
San Andrés
,
L.
,
2010
, “
Annular Pressure (Damper) Seals
,”
Modern Lubrication Theory
,
Texas A&M University Digital Libraries
,
College Station, TX
, accessed Oct. 21, 2017, http://oaktrust.library.tamu.edu/handle/1969.1/93197
24.
Ruud
,
F. O.
,
1976
, “
Vibration of Deriaz Pumps at Dos Amigos Pumping Plant
,”
ASME J. Fluids Eng.
,
98
(
4
), pp.
674
679
.
25.
Smith
,
D. R.
,
Price
,
S. M.
, and
Kunz
,
F. K.
,
1996
, “
Centrifugal Pump Vibration Caused by Supersynchronous Shaft Instability Use of Pumpout Vanes to Increase Pump Shaft Stability
,”
13th International Pump Users Symposium
, Houston, TX, Mar. 5–7, pp. 47–60.
26.
Andrews
,
M. J.
, and
O'Rourke
,
P. J.
,
1996
, “
The Multiphase Particle-in-Cell (MP-PIC) Method for Dense Particulate Flows
,”
Int. J. Multiphase Flow
,
22
(
2
), pp.
379
402
.
You do not currently have access to this content.