With the transition of the power production markets toward renewable energy sources, an increased demand for flexible, fossil-based power production systems arises. Steep load gradients and a high range of flexibility make gas turbines a core technology in this ongoing change. In order to further increase this flexibility research on power augmentation of premixed gas turbine combustors is conducted at the Lehrstuhl für Thermodynamik, TU München. Water injection in gas turbine combustors allows for the simultaneous control of NOx emissions as well as the increase of the power output of the engine and has therefore been transferred to a premixed combustor at lab scale. So far stable operation of the system has been obtained for water-to-fuel ratios up to 2.25 at constant adiabatic flame temperatures. This paper focuses on the effects of water injection on pollutant formation in premixed gas turbine flames. In order to guarantee for high practical relevance, experimental measurements are conducted at typical preheating temperatures and common gas turbine combustor residence times of about 20 ms. Spatially resolved and global species measurements are performed in an atmospheric single burner test rig for typical adiabatic flame temperatures between 1740 and 2086 K. Global measurements of NOx and CO emissions are shown for a wide range of equivalence ratios and variable water-to-fuel ratios. Cantera calculations are used to identify nonequilibrium processes in the measured data. To get a close insight into the emission formation processes in water-injected flames, local concentration measurements are used to calculate distributions of the reaction progress variable. Finally, to clarify the influence of spray quality on the composition of the exhaust gas, a variation of the water droplet diameters is done. For rising water content at constant adiabatic flame temperature, the NOx emissions can be held constant, whereas CO concentrations increase. On the contrary, both values decrease for measurements at constant equivalence ratio and reduced flame temperatures. Further analysis of the data shows the close dependency of CO concentration on the equivalence ratio; however, due to the water addition, a shift of the CO curves can be detected. In the local measurements, changes in the distribution of the reaction progress variable and an increase of the flame length were detected for water-injected flames along with changes of the maximum as well as the averaged CO values. Finally, a strong influence of water droplet size on NOx and CO formation is shown for constant operating conditions.

References

References
1.
Moore
,
M.
,
1997
, “
NOx Emission Control in Gas Turbines for Combined Cycle Gas Turbine Plant
,”
Proc. Inst. Mech. Eng., Part A: J. Power Energy
,
211
(
1
), pp. 43–52.
2.
Göke
,
S.
,
2012
, “Ultra-Wet Combustion: An Experimental and Numerical Study,”
Ph.D. thesis
, Technische Universität Berlin, Berlin.https://depositonce.tu-berlin.de/bitstream/11303/3747/1/Dokument_20.pdf
3.
Göckeler
,
K.
,
2015
, “Influence of Steam Dilution and Hydrogen Enrichment on Laminar Premixed Methane Flames,”
Ph.D. thesis
, Technische Universität Berlin, Berlin.
4.
Seiser
,
R.
, and
Seshadri
,
K.
,
2005
, “
The Influence of Water on Extinction and Ignition of Hydrogen and Methane Flames
,”
Proc. Combust. Inst.
,
30
(
1
), pp. 407–414.
5.
Bhargava
,
A.
,
Colket
,
M.
,
Sowa
,
W.
,
Casleton
,
K.
, and
Maloney
,
D.
,
2000
, “
An Experimental and Modeling Study of Humid Air Premixed Flames
,”
ASME J. Eng. Gas Turbines Power
,
122
(
3
), pp. 405–411.
6.
Le Cong
,
T.
, and
Dagaut
,
P.
,
2009
, “
Experimental and Detailed Modeling Study of the Effect of Water Vapor on the Kinetics of Combustion of Hydrogen and Natural Gas, Impact on NOx
,”
Energy Fuels
,
23
(
2
), pp. 725–734.
7.
Zhao
,
D.
,
Yamashita
,
H.
,
Kitagawa
,
K.
,
Arai
,
N.
, and
Furuhata
,
T.
,
2002
, “
Behavior and Effect on NOx Formation of OH Radical in Methane-Air Diffusion Flame With Steam Addition
,”
Combust. Flame
,
130
(
4
), pp. 352–360.
8.
Göke
,
S.
,
Göckeler
,
K.
,
Krüger
,
O.
, and
Paschereit
,
C. O.
,
2010
, “Computational and Experimental Study of Premixed Combustion at Ultra Wet Conditions,”
ASME
Paper No. GT2010-23417.
9.
Sangl
,
J.
,
Mayer
,
C.
, and
Sattelmayer
,
T.
,
2011
, “
Dynamic Adaptation of Aerodynamic Flame Stabilization of a Premix Swirl Burner to Fuel Reactivity Using Fuel Momentum
,”
ASME J. Eng. Gas Turbines Power
,
133
(
7
), p. 071501.
10.
Goodwin
,
D. G.
,
Moffat
,
H. K.
, and
Speth
,
R. L.
,
2016
, “
Cantera: An Object-Oriented Software Toolkit for Chemical Kinetics, Thermodynamics, and Transport Processes
,”
Version 2.2.1
, Cantera Developers.https://zenodo.org/record/45206#.WfGBh1uCzZ4
11.
Smith
,
G. P.
,
Golden
,
D. M.
,
Frenklach
,
M.
,
Moriarty
,
N. W.
,
Eiteneer
,
B.
,
Goldenberg
,
M.
,
Bowman
,
C. T.
,
Hanson
,
R. K.
,
Song
,
S.
,
William
,
C.
,
Gardiner
,
J.
,
Lissianski
,
V. V.
, and
Qin
,
Z.
,
2016
, “Berkeley GRI Mech 3.0,” GRI Mech, accessed Oct. 26, 2017, http://www.me.berkeley.edu/gri_mech/
12.
Miyauchi
,
T.
,
Mori
,
Y.
, and
Yamaguchi
,
H.
,
1981
, “
Effect of Steam Addition on NO Formation
,”
Eighteenth Symposium (International) on Combustion
, Waterloo, ON, Canada, Aug. 17–22.
13.
Lellek
,
S.
, and
Sattelmayer
,
T.
,
2015
, “Influence of Water Injection on Heat Release Distribution, Lean Blowout and Emissions of a Premixed Swirl Flame in a Tubular Combustor,”
ASME
Paper No. GT2015-42602.
14.
Lellek
,
S.
,
Barfuß
,
C.
, and
Sattelmayer
,
T.
,
2016
, “
Experimental Study of the Interaction of Water Sprays With Swirling Premixed Natural Gas Flames
,”
ASME J. Eng. Gas Turbines Power
,
139
(
2
), p.
021506
.
15.
Lechner
,
C.
, and
Seume
,
J.
,
2010
,
Stationäre Gasturbinen
,
Springer
, Berlin.
16.
Joos
,
F.
,
2006
,
Technische Verbrennung
,
Springer
, Berlin.
You do not currently have access to this content.