Jet-stabilized combustion is a promising technology for fuel flexible, reliable, highly efficient combustion systems. The aim of this work is a reduction of NOx emissions of a previously published two-stage micro gas turbine (MGT) combustor (Zanger et al., 2015, “Experimental Investigation of the Combustion Characteristics of a Double-Staged FLOX-Based Combustor on an Atmospheric and a Micro Gas Turbine Test Rig,” ASME Paper No. GT2015-42313 and Schwärzle et al., 2016, “Detailed Examination of Two-Stage Micro Gas Turbine Combustor,” ASME Paper No. GT2016-57730), where the pilot stage (PS) of the combustor was identified as the main contributor to NOx emissions. The geometry optimization was carried out regarding the shape of the pilot dome and the interface between PS and main stage (MS) in order to prevent the formation of high-temperature recirculation zones. Both stages have been run separately to allow a detailed understanding of the flame stabilization within the combustor, its range of stable combustion, the interaction between both stages, and the influence of the modified geometry. All experiments were conducted at atmospheric pressure and an air preheat temperature of 650 . The flame was analyzed in terms of shape, length, and lift-off height, using OH* chemiluminescence (OH-CL) images. Emission measurements for NOx, CO, and unburned hydrocarbons (UHC) emissions were carried out. At a global air number of λ = 2, a fuel split variation was carried out from 0 (only PS) to 1 (only MS). The modification of the geometry leads to a decrease in NOx and CO emissions throughout the fuel split variation in comparison with the previous design. Regarding CO emissions, the PS operations are beneficial for a fuel split above 0.8. The local maximum in NOx emissions observed for the previous combustor design at a fuel split of 0.78 was not apparent for the modified design. NOx emissions were increasing, when the local air number of the PS was below the global air number. In order to evaluate the influence of the modified design on the flow field and identify the origin of the emission reduction compared to the previous design, unsteady Reynolds-averaged Navier–Stokes simulations were carried out for both geometries at fuel splits of 0.93 and 0.78, respectively, using the DLR (German Aerospace Center) in-house code turbulent heat release extension of the tau code (theta) with the k–ω shear stress transport turbulence model and the DRM22 (Kazakov and Frenklach, 1995, “DRM22,” University of California at Berkeley, Berkeley, CA, accessed Sept. 21, 2017, http://www.me.berkeley.edu/drm/) detailed reaction mechanism. The numerical results showed a strong influence of the recirculation zones on the PS reaction zone.
Skip Nav Destination
Article navigation
February 2018
Research-Article
Detailed Examination of a Modified Two-Stage Micro Gas Turbine Combustor
Andreas Schwärzle,
Andreas Schwärzle
Institute of Combustion Technology,
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
e-mail: andreas.schwaerzle@dlr.de
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
e-mail: andreas.schwaerzle@dlr.de
Search for other works by this author on:
Thomas O. Monz,
Thomas O. Monz
Institute of Combustion Technology,
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
Search for other works by this author on:
Andreas Huber,
Andreas Huber
Institute of Combustion Technology,
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
Search for other works by this author on:
Manfred Aigner
Manfred Aigner
Institute of Combustion Technology,
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
Search for other works by this author on:
Andreas Schwärzle
Institute of Combustion Technology,
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
e-mail: andreas.schwaerzle@dlr.de
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
e-mail: andreas.schwaerzle@dlr.de
Thomas O. Monz
Institute of Combustion Technology,
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
Andreas Huber
Institute of Combustion Technology,
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
Manfred Aigner
Institute of Combustion Technology,
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
German Aerospace Center (DLR),
Pfaffenwaldring 38-40,
Stuttgart 70569, Germany
1Corresponding author.
Contributed by the Combustion and Fuels Committee of ASME for publication in the JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER. Manuscript received July 5, 2017; final manuscript received July 18, 2017; published online October 3, 2017. Editor: David Wisler.
J. Eng. Gas Turbines Power. Feb 2018, 140(2): 021501 (10 pages)
Published Online: October 3, 2017
Article history
Received:
July 5, 2017
Revised:
July 18, 2017
Citation
Schwärzle, A., Monz, T. O., Huber, A., and Aigner, M. (October 3, 2017). "Detailed Examination of a Modified Two-Stage Micro Gas Turbine Combustor." ASME. J. Eng. Gas Turbines Power. February 2018; 140(2): 021501. https://doi.org/10.1115/1.4037749
Download citation file:
Get Email Alerts
Cited By
Blade Excitation Alleviation of a Nozzleless Radial Turbine by Casing Treatment Based on Reduced Order Mode
J. Eng. Gas Turbines Power
Design And Testing of a Compact, Reverse Brayton Cycle, Air (R729) Cooling Machine
J. Eng. Gas Turbines Power
Experimental Study on Liquid Jet Trajectory in Cross Flow of Swirling Air at Elevated Pressure Condition
J. Eng. Gas Turbines Power
Related Articles
Experimental and Numerical Investigation of Fuel–Air Mixing in a Radial Swirler Slot of a Dry Low Emission Gas Turbine Combustor
J. Eng. Gas Turbines Power (June,2016)
Numerical Study of Radiation and Fuel–Air Unmixedness on the Performance of a Dry Low NOx Combustor
ASME Open J. Engineering (January,2022)
Hydrogen Enriched Combustion Testing of Siemens Industrial SGT-400 at Atmospheric Conditions
J. Eng. Gas Turbines Power (February,2015)
Emissions of a Wet Premixed Flame of Natural Gas and a Mixture With Hydrogen at High Pressure
J. Eng. Gas Turbines Power (April,2017)
Related Proceedings Papers
Related Chapters
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Low Emissions Engine Combustor Technology Evolution
International Conference on Computer Technology and Development, 3rd (ICCTD 2011)
Combined Cycle Power Plant
Energy and Power Generation Handbook: Established and Emerging Technologies