The reduction of full and part load emissions and the increase of the turndown ratio are important goals for gas turbine combustor development. Combustion techniques, which generate lower NOx emissions than unstaged premixed combustion in the full load range, and which have the potential of reducing minimum load while complying with emission legislation, are of high technical interest. Therefore, axial-staged combustion systems have been designed, either with or without expansion in a turbine stage between both stages. In its simpler form without intermediate expansion stage, a flow of hot combustion products is generated in the first stage of the premixed combustor, which interacts with the jets of premixed gas injected into the second stage. The level of NOx formation during combustion of the premixed jets in the hot cross flow determines the advantage of axially staged combustion regarding full load NOx emission reduction. Employing large-eddy simulation in openfoam, a tool has been developed, which allows to investigate staged combustion systems including not only temperature distribution but also NOx emissions under engine conditions. To be able to compute NOx formation correctly, the combustion process has to be captured with sufficient level of accuracy. This is achieved by the partially stirred reactor model. It is combined with a newly developed NOx model, which is a combination of a tabulation technique for the NOx source term based on mixture fraction and progress variable and a partial equilibrium approach. The NOx model is successfully validated with generic burner stabilized flame data and with measurements from a large-scale reacting jet in cross flow experiment. The new NOx model is finally used to compute a reacting jet in cross flow under engine conditions to investigate the NOx formation of staged combustion in detail. The comparison between the atmospheric and the pressurized configuration gives valuable insight in the NOx formation process. It can be shown that the NOx formation within a reacting jet in cross flow configuration is reduced and not only diluted.

References

References
1.
International Energy Agenc
y,
2013
, “
Energy Policies of IEA Countries: Germany
,”
International Energy Agency
, Paris, France.
2.
Ahrens
,
D.
,
Kolb
,
M.
,
Hirsch
,
C.
, and
Sattelmayer
,
T.
,
2015
, “
NOx Formation in a Reacting Premixed Jet in Hot Cross Flow
,”
ASME
Paper No. GT2014-26139.
3.
Hirano
,
K.
,
Nonaka
,
Y.
,
Kinoshita
,
Y.
,
Oshima
,
N.
, and
Matsuya
,
K.
,
2012
, “
Large Eddy Simulation in an Industrial Gasturbine Combustor for NOx Prediction
,”
ASME
Paper No. GT2012-68925.
4.
Cannon
,
S.
,
Smith
,
C.
, and
Anand
,
M.
,
2003
, “
LES Predictions of Combustor Emissions in a Practical Gas Turbine Combustor
,”
AIAA
Paper No. 4521.
5.
Ihme
,
M.
, and
Pitsch
,
H.
,
2008
, “
Modeling of Radiation and Nitric Oxide Formation in Turbulent Nonpremixed Flames Using a Flamelet/Progress Variable Formulation
,”
Phys. Fluids
,
20
(
5
), pp.
1
20
.
6.
Collonval
,
F.
, and
Polifke
,
W.
,
2014
, “
Modelling the Formation of Oxides of Nitrogen in Premix Combustion by Extending Tabulated Chemistry With Algebraic Relations
,”
ASME
Paper No. GT2014-27293.
7.
Turns
,
S. R.
,
2000
,
An Introduction to Combustion
,
McGraw-Hill
,
Boston, MA
.
8.
Kutsenko
,
Y. G.
, and
Onegin
,
S. F.
,
2006
, “
Development and Application of CFD-Based Analysis Methodology to Evaluate Efficiency of Low NOx Combustion Technologies
,”
ASME
Paper No. GT2006-90530.
9.
Hanson
,
R. K.
, and
Salimian
,
S.
,
1984
, “
Survey of Rate Constants in the N/H/O System
,”
Combustion Chemistry
,
W. C.
Gardiner
, Jr.
, ed.,
Springer
,
New York
, pp.
362
421
.
10.
Smith
,
G. P.
,
Golden
,
D. M.
,
Frenklach
,
M.
,
Moriarty
,
N. W.
,
Eiteneer
,
B.
,
Goldenberg
,
M.
,
Bowman
,
C. T.
,
Hanson
,
R. K.
,
Song
,
S.
,
Gardiner
,
W. C.
, Jr.
,
Lissianski
,
V. V.
, and
Qin
,
Z.
, “
GRI-Mech
,”
University of California
, Berkeley, CA.
11.
Westbrook
,
C. K.
, and
Dryer
,
F. L.
,
1981
, “
Simplified Reaction Mechanisms for the Oxidation of Hydrocarbon Fuels in Flames
,”
Combust. Sci. Technol.
,
27
, pp.
31
43
.
12.
SGI
,
2012
, “
OpenFOAM User Guide
,”
SGI Corp.
,
Milpitas, CA
.
13.
Germano
,
M.
,
Piomelli
,
U.
,
Moin
,
P.
, and
Carbot
,
W.
,
1991
, “
A Dynamic Subgrid-Scale Eddy Viscosity Model
,”
Phys. Fluids
,
7
(
A3
), pp.
1760
1765
.
14.
Lilly
,
D. K.
,
1992
, “
A Proposed Modification of the Germano Subgrid-Scale Closure Method
,”
Phys. Fluids
,
4
(
3
), pp.
633
635
.
15.
Kempf
,
A.
,
Klein
,
M.
, and
Janicka
,
J.
,
2005
, “
Efficient Generation of Initial- and Inflow-Conditions for Transient Turbulent Flows in Arbitrary Geometries
,”
Flow Turbul. Combust.
,
74
(
1
), pp.
67
84
.
16.
Golovitchec
,
V.
, and
Chomiak
,
J.
,
2001
, “
Numerical Modeling of high Temperature Air ‘Flameless Combustion
,’”
4th International Symposium on High Temperature Air Combustion and Gasification
, Rome, Italy, Nov. 27–30.
17.
Schmitt
,
D.
,
Kolb
,
M.
,
Weinzierl
,
J.
,
Hirsch
,
C.
, and
Sattelmayer
,
T.
,
2013
, “
Ignition and Flame Stabilization of a Premixed Jet in Hot Cross Flow
,”
ASME
Paper No. GT2013-94763.
You do not currently have access to this content.