Squeeze film dampers (SFDs) are commonly used in turbomachinery to dampen shaft vibrations in rotor-bearing systems. The main factor deterring the success of analytical models for the prediction of SFD’s performance lies on the modeling of dynamic film rupture. Usually, the cavitation models developed for journal bearings are applied to SFDs. Yet, the characteristic motion of the SFD results in the entrapment of air into the oil film, producing a bubbly mixture that cannot be represented by these models. There is a need to identify and understand the parameters that affect air entrainment and subsequent formation of a bubbly air-oil mixture within the lubricant film. A previous model by and Diazand San Andrés (2001, “A Model for Squeeze Film Dampers Operating With Air Entrapment and Validation With Experiments,” ASME J. Tribol., 123, pp. 125–133) advanced estimation of the amount of film-entrapped air based on a nondimensional number that related both geometrical and operating parameters but limited to the short bearing approximation (i.e., neglecting circumferential flow). The present study extends their work to consider the effects of finite length-to-diameter ratios. This is achieved by means of a finite volume integration of the two-dimensional, Newtonian, compressible Reynolds equation combined with the effective mixture density and viscosity defined in the work of Diaz and San Andrés. A flow balance at the open end of the film is devised to estimate the amount of air entrapped within the film. The results show, in dimensionless plots, a map of the amount of entrained air as a function of the feed-squeeze flow number, defined by Diaz and San Andrés, and the length-to-diameter ratio of the damper. Entrained air is shown to decrease as the $L/D$ ratio increases, going from the approximate solution of Diaz and San Andrés for infinitely short SFDs down to no air entrainment for an infinite length SFD. The results of this research are of immediate engineering applicability. Furthermore, they represent a firm step to advance the understanding of the effects of air entrapment on the performance of SFDs.

1.
San Andrés
,
L.
, and
Vance
,
J. M.
, 1986, “
Experimental Measurement of the Dynamic Pressure Distributions in a Squeeze Film Damper Executing Circular-Centred Orbits
,”
ASLE Trans.
0569-8197
30
(
3
), pp.
373
383
.
2.
Childs
,
D.
, 1993,
Turbomachinery Rotodynamics
,
Wiley
,
New York
.
3.
Zeidan
,
F. Y.
, and
Vance
,
J. M.
, 1989, “
Experimental Investigation of Cavitation Effects on the Squeeze Film Force Coefficients
,” Rotating Machinery Dynamics,
Proceedings of the 12th Biennial ASME Conference on Mechanical Vibration and Noise
, Montreal , Canada; US, Sep. 17–21, pp. 237–242.
4.
Zeidan
,
F. Y.
, and
Vance
,
J. M.
, 1989, “
Cavitation Leading to a Two Phase Fluid in a Squeeze Film Damper
,”
STLE Tribol. Trans.
1040-2004,
32
(
1
), pp.
100
104
.
5.
Zeidan
,
F. Y.
, and
Vance
,
J. M.
, 1990, “
Cavitation Regimes in Squeeze Film Dampers and Their Effect on the Pressure Distribution
,”
STLE Tribol. Trans.
1040-2004,
33
, pp.
447
453
.
6.
Walton
,
J.
,
Walowit
,
E.
,
Zorzi
,
E.
, and
Schrand
,
J.
, 1987, “
Experimental Observation of Cavitating Squeeze Film Dampers
,”
ASME J. Tribol.
0742-4787,
109
, pp.
290
295
.
7.
San Andres
,
L.
, and
De Santiago
,
O.
, 2004, “
Dynamic Response of Squeeze Film Dampers Operating With Bubbly Mixtures
,”
ASME J. Eng. Gas Turbines Power
0742-4795,
126
, pp.
408
415
.
8.
Diaz
,
S.
, and
San Andrés
,
L.
, 2001, “
A Model for Squeeze Film Dampers Operating With Air Entrapment and Validation With Experiments
,”
ASME J. Tribol.
0742-4787,
123
, pp.
125
133
.
9.
Diaz
,
S.
, 1999, “
The Effect of Air Entrapment on the Performance of Squeeze Film Dampers: Experiments and Analysis
,” Ph.D. thesis, Texas A&M University, College Station, TX.
10.
Tonnesen
,
J.
, 1976, “
Experimental Parametric Study of a Squeeze Film Bearing
,”
J. Lubr. Technol.
0022-2305,
April
, pp.
206
213
.
11.
San Andrés
,
L.
, 1992, “
Analysis of Short Squeeze Film Dampers With a Central Groove
,”
ASME J. Tribol.
0742-4787,
114
, pp.
659
665
.
12.
Chen
,
P. Y. P.
, and
Hahn
,
E. J.
, 1994, “
Pressure Distribution in Squeeze Film Dampers With Oil Hole Feed
,”
Proc. Inst. Mech. Eng., Part J: J. Eng. Tribol.
1350-6501,
208
, pp.
105
112
.
13.
Rodriguez
,
F.
,
Thouverez
,
F.
, and
Jezequel
,
L.
, 2004, “
Interaction of Squeeze Film Dampers and Hole Feed Systems and Its Influence on the Dynamics of a Jeffcott Rotor
,”
Int. J. Rotating Mach.
1023-621X,
10
(
3
), pp.
163
174
.
14.
Diaz
,
S. E.
, and
San Andrés
,
L.
, 1998, “
Measurements of Pressure in a Squeeze Film Damper With an Air/Oil Bubbly Mixture
,”
STLE Tribol. Trans.
1040-2004,
41
(
2
), pp.
282
288
.
15.
San Andrés
,
L.
, and
Diaz
,
S.
, 2002, “
Pressure Measurements and Flow Visualization in a Squeeze Film Damper Operating in a Bubbly mixture
,”
Trans. ASME, J. Tribol.
0742-4787,
124
, pp.
346
350
.
16.
San Andrés
,
L.
, and
Diaz
,
S.
, 2003, “
Flow Visualization and Forces From a Squeeze Film Damper Operanting With Air Entrainment
,”
ASME J. Tribol.
0742-4787,
125
, pp.
325
333
.
17.
Arghir
,
M.
,
Alsayed
,
A.
, and
Nicolas
,
D.
, 2002, “
The Finite Volume Solution of the Reynolds Equation of Lubrication With Film Discontinuities
,”
Int. J. Mech. Sci.
0020-7403,
44
, pp.
2119
2132
.
18.
Diaz
,
S. E.
, and
San Andrés
,
L.
, 1999, “
Reduction of the Dynamic Load Capacity in a Squeeze Film Damper Operating With a Bubbly Mixture
,”
ASME J. Eng. Gas Turbines Power
0742-4795,
121
, pp.
703
709
.