Predictions are presented for an annular gas seal that is representative of the division-wall seal of a back-to-back compressor or the balance-piston seal of an in-line compressor. A two-control-volume bulk-flow model is used including the axial and circumferential momentum equations and the continuity equations. The basic model uses a constant-temperature prediction (ISOT) and an ideal gas law as an equation of state. Two variations are used: adding the energy equation with an ideal gas law (IDEAL), and adding the energy equation with real gas properties (REAL). The energy equations assume adiabatic flow. The ISOT model has been used for prior calculations. Concerning predictions of static characteristics, the calculated mass leakage rates were, respectively, 9.46 kg∕s, 9.55 kg∕s, and 7.87 kg∕s for ISOT, IDEAL, and REAL. For rotordynamic coefficients, predicted effective stiffness coefficients are comparable for the models at low excitation frequencies. At running speed, REAL predictions are roughly 40% lower than ISOT, which could result in lower predicted critical speeds. Predicted effective damping coefficients are also generally comparable. REAL and IDEAL predictions for the crossover frequency are approximately 20% lower than ISOT. REAL predictions for effective damping are modestly lower in the frequency range of 40–50% of running speed where higher damping values are desired.
The Impact of Real Gas Properties on Predictions of Static and Rotordynamic Properties of the Annular Gas Seals for Injection Compressors
- Views Icon Views
- Share Icon Share
- Search Site
Shin, Y., and Childs, D. W. (April 29, 2008). "The Impact of Real Gas Properties on Predictions of Static and Rotordynamic Properties of the Annular Gas Seals for Injection Compressors." ASME. J. Eng. Gas Turbines Power. July 2008; 130(4): 042504. https://doi.org/10.1115/1.2904891
Download citation file: