Calculations of the performance of modern gas turbines usually include allowance for cooling air flow rate; assumptions are made for the amount of the cooling air bled from the compressor, as a fraction of the mainstream flow, but this fractional figure is often set in relatively arbitrary fashion. There are two essential effects of turbine blade cooling: (i) the reduction of the gas stagnation temperature at exit from the combustion chamber (entry to the first nozzle row) to a lower stagnation temperature at entry to the first rotor and (ii) a pressure loss resulting from mixing the cooling air with the mainstream. Similar effects occur in the following cooled blade rows. The paper reviews established methods for determining the amount of cooling air required and semi-empirical relations, for film cooled blading with thermal barrier coatings, are derived. Similarly, the pressure losses related to elements of cooling air leaving at various points round the blade surface are integrated over the whole blade. This gives another semi-empirical expression, this time for the complete mixing pressure loss in the blade row, as a function of the total cooling air used. These two relationships are then used in comprehensive calculations of the performance of a simple open-cycle gas turbine. for varying combustion temperature and pressure ratio. These calculations suggest that for maximum plant efficiency there may be a limiting combustion temperature (below that which would be set by stoichiometric combustion). For a given combustion temperature, the optimum pressure ratio is reduced by the effect of cooling air.
Skip Nav Destination
Article navigation
July 2001
Technical Papers
Limitations on Gas Turbine Performance Imposed by Large Turbine Cooling Flows
J. H. Horlock,
J. H. Horlock
Whittle Laboratory, Engineering Department, Cambridge University, Madinglet Road, Cambridge CB3 0DY UK
Search for other works by this author on:
T. V. Jones
T. V. Jones
Osney Laboratory, Engineering Science Department, Oxford University, Oxford, UK
Search for other works by this author on:
J. H. Horlock
Whittle Laboratory, Engineering Department, Cambridge University, Madinglet Road, Cambridge CB3 0DY UK
D. T. Watson
Rolls Royce plc, Derby, UK
T. V. Jones
Osney Laboratory, Engineering Science Department, Oxford University, Oxford, UK
Contributed by the Advanced Energy Systems Division of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for publication in the ASME JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER. Manuscript received by the AES Division, Sept. 2000; final revision, Feb. 2001. Editor: H. D. Nelson.
J. Eng. Gas Turbines Power. Jul 2001, 123(3): 487-494 (8 pages)
Published Online: February 1, 2001
Article history
Received:
September 1, 2000
Revised:
February 1, 2001
Citation
Horlock, J. H., Watson, D. T., and Jones, T. V. (February 1, 2001). "Limitations on Gas Turbine Performance Imposed by Large Turbine Cooling Flows ." ASME. J. Eng. Gas Turbines Power. July 2001; 123(3): 487–494. https://doi.org/10.1115/1.1373398
Download citation file:
Get Email Alerts
Numerical Investigation of CO and NO Production From Premixed Hydrogen/Methane Fuel Blends
J. Eng. Gas Turbines Power (April 2025)
An Efficient Uncertainty Quantification Method Based on Inter-Blade Decoupling for Compressors
J. Eng. Gas Turbines Power (April 2025)
Experimental Design Validation of a Swirl-Stabilized Burner With Fluidically Variable Swirl Number
J. Eng. Gas Turbines Power (April 2025)
Experimental Characterization of a Bladeless Air Compressor
J. Eng. Gas Turbines Power (April 2025)
Related Articles
Analytical Blade Row Cooling Model for Innovative Gas Turbine Cycle Evaluations Supported by Semi-Empirical Air-Cooled Blade Data
J. Eng. Gas Turbines Power (July,2004)
Effects of a Reacting Cross-Stream on Turbine Film Cooling
J. Eng. Gas Turbines Power (May,2010)
Qualitative and Quantitative Comparison of Two Promising Oxy-Fuel Power Cycles for C O 2 Capture
J. Eng. Gas Turbines Power (May,2008)
The Expansion-Cycle Evaporation Turbine
J. Eng. Gas Turbines Power (May,2012)
Related Chapters
Control and Operational Performance
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Introduction
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential