Fundamental heat transfer experiments were carried out for three kinds of heat pipes that may be applied to turbine cooling in future aero-engines. In the turbine cooling system with a heat pipe, heat transfer rate and start-up time of the heat pipe are the most important performance criteria to evaluate and compare with conventional cooling methods. Three heat pipes are considered, called heat pipe A, B, and C, respectively. All heat pipes have a stainless steel shell and nickel sintered powder metal wick. Sodium (Na) was the working fluid for heat pipes A and B; heat pipe C used eutectic sodium-potassium (NaK). Heat pipes B and C included noncondensible gas for rapid start-up. There were fins on the cooling section of heat pipes. In the experiments, and infrared image furnace supplied heat to the heat pipe simulating turbine blade surface conditions. In the results, heat pipe B demonstrated the highest heat flux of 17 to 20 W/cm2. The start-up time was about 6 minutes for heat pipe B and about 16 minutes for heat pipe A. Thus, adding noncondensible gas effectively reduced start-up time. Although NaK is a liquid phase at room temperature, the startup time of heat pipe C (about 7 to 8 minutes) was not shorter than the heat pipe B. The effect of a gravitational force on heat pipe performance was also estimated by inclining the heat pipe at an angle of 90 deg. There was no significant gravitational dependence on heat transport for heat pipes including noncondensible gas.

Anderson, W. G., Hoff, S., and Winstanley, D., 1993a, “Heat Pipe Cooling of Turboshaft Engines,” ASME Paper 93-GT-220.
Anderson, W. G., 1993b, “Negative Pressure in Alkali Metal Heat Pipes,” AIAA Paper 93-3904, ASME/AIChE 29th National Heat Transfer Conference.
W. G.
c, “
Sodium-Potassium (NaK) Heat Pipe
Heat Pipes and Capillary Pumped Loops
, A. Faghri et al., eds., ASME HTD-Vol.
, pp.
Cao, Y., and Faghri, A., 1992, “Analysis of High Temperature Heat Pipe Startup from the Frozen State: Part 1—Numerical Simulation,” Topic in Heat Transfer—Volume 3, ASME HTD-Vol. 206-3.
Chi, S. W., 1976, Heat Pipe Theory and Practice: A Source Book, Practical Technology Series, Hemisphere, Bristol, PA.
Kays, W. M., and Crawford, M. E., 1980, Convective Heat and Mass Transfer, 2nd ed., McGraw-Hill, NY, p. 270.
Ponnappan, R., and Chang, W. S., 1994, “Startup Performance of a Liquid Metal Heat Pipe in Near Vacuum and Gas-Loaded Modes,” Journal of Thermophysics and Heat Transfer, pp. 164–171.
Silverstein, C. C., Gottschlich, M. J., and Meininger, M., 1994, “The Feasibility of Heat Pipe Turbine Vane Cooling,” ASME Paper 94-GT-306.
Yoshida, T., Taki, M., Mimura, F., Kumagai, T., Maya, T., and Yamawaki, S., 1993, “A New Cooling System for Ultra High Temperature Turbines,” 11th International Symposium on Air Breathing Engines, proceedings, pp. 749–756.
This content is only available via PDF.
You do not currently have access to this content.