Altitude pressure and temperature inlet distortion testing of the two-stage centrifugal compressor in the T800-LHT-800 engine is described. The test setup and the testing techniques are reviewed and the results of the test are presented. The generation of classical 180 deg patterns of both pressure and temperature distortion is discussed. Temperature distortion was created using a hydrogen burner system while pressure distortion was created in the classical manner, using screens. Results of both individual and combined temperature and pressure distortions in both opposed and concurrent patterns are shown.
Issue Section:Gas Turbines: Heat Transfer
Topics:Compressors, Pressure, Temperature, Testing, Engines, Hydrogen
This content is only available via PDF.
Copyright © 1994
by The American Society of Mechanical Engineers