Abstract
Common paving materials—concrete and asphalt—pose an unusual and complex barrier to disinterment and examination of human remains. Although not commonly encountered, these materials are seen with sufficient frequency to justify consideration of the procedures and equipment necessary for disinterment. Over a seven year period we have encountered paving materials seven times. In each of these cases, the material was slightly different in quality, and different tools—including heavy construction equipment—were necessary. Sometimes the paving material could be managed without heavy power tools, but occasionally specialized construction tools have proven very useful.
Issue Section:
Research Papers
References
1.
Boyd
R. M.
, “Buried Body Cases
,” FBI Law Enforcement Bulletin
, Vol. 48
, 1979
, pp. 1
-7
.2.
Mant
, A. K.
, “Postmortem Injuries
,” Forensic Medicine
, C. G.
Tedeschi
, W. C.
Eckert
, and L. G.
Tedeschi
, Eds., W. B. Saunders Co.
, Philadelphia
, 1977
, pp. 1061
-1066
.3.
Bass
, W. M.
and Birkby
, W. H.
, “Exhumation: The Method Could Make the Difference
,” FBI Law Enforcement Bulletin
, Vol. 47
, 1979
, pp. 6
-11
.4.
Hawley
, D. A.
, Doedens
, D. J.
, McClain
, J. L.
, and Pless
, J. E.
, “Concealment of the Body in Drug Deaths
,” Journal of Forensic Sciences
0022-1198, Vol. 34
, No. 2
, 03
1989
, pp. 495
-499
.5.
Ellenhorn
, M. J.
and Barceloux
, D. G.
, “Hydrocarbon Products and Aliphatic Hydrocarbons
,” Medical Toxicology: Diagnosis and Treatment of Human Poisoning
, Elsevier Science Publishing Company, Inc.
, New York
, 1988
, pp. 940
-968
.6.
Malhotra
, V. M.
, “Applications of X-Radiography
,” Testing Hardened Concrete: Nondestructive Methods, ACI Monograph No. 9
, Iowa State University Press and The American Concrete Institute
, Detroit
, 1976
, pp. 111
-125
.
This content is only available via PDF.
All rights reserved. This material may not be reproduced or copied, in whole or in part, in any printed, mechanical, electronic, film, or other distribution and storage media, without the written consent of ASTM International.
You do not currently have access to this content.