This paper presents a numerical model of transient flow in a pressure slurry pipeline network with verification based on in situ measurements. The model, primarily verified in laboratory conditions, has been extended and applied to the case of a large and complex slurry pipeline network in Poland. In the model, the equivalent density concept was applied. In situ experiments were performed for various unsteady flow episodes, caused by different pump operation strategies in the industrial pipeline network. Based on the measurements of slurry concentration and pressure variations, the numerical model was tested and verified. A satisfactory coincidence between the calculated and the observed pressure characteristics was achieved. Additional numerical tests led to important conclusions concerning safe pump and valve operation and system security threats.
Skip Nav Destination
Article navigation
August 2019
Research-Article
In Situ Verification of Numerical Model of Water Hammer in Slurries
Apoloniusz Kodura,
Apoloniusz Kodura
Faculty of Building Services,
Hydro and Environmental Engineering,
Warsaw University of Technology,
20 Nowowiejska Street,
Warsaw 00-653, Poland
e-mail: apoloniusz.kodura@pw.edu.pl
Hydro and Environmental Engineering,
Warsaw University of Technology,
20 Nowowiejska Street,
Warsaw 00-653, Poland
e-mail: apoloniusz.kodura@pw.edu.pl
1Corresponding author.
Search for other works by this author on:
Katarzyna Weinerowska-Bords,
Katarzyna Weinerowska-Bords
Department of Civil and
Environmental Engineering,
Gdansk University of Technology,
11-12 Gabriela Narutowicza Street,
Gdańsk 80-233, Poland
e-mail: kwein@pg.edu.pl
Environmental Engineering,
Gdansk University of Technology,
11-12 Gabriela Narutowicza Street,
Gdańsk 80-233, Poland
e-mail: kwein@pg.edu.pl
Search for other works by this author on:
Wojciech Artichowicz,
Wojciech Artichowicz
Department of Civil and
Environmental Engineering,
Gdansk University of Technology,
11-12 Gabriela Narutowicza Street,
Gdańsk 80-233, Poland
e-mail: wojartic@pg.edu.pl
Environmental Engineering,
Gdansk University of Technology,
11-12 Gabriela Narutowicza Street,
Gdańsk 80-233, Poland
e-mail: wojartic@pg.edu.pl
Search for other works by this author on:
Michał Kubrak,
Michał Kubrak
Faculty of Building Services,
Hydro and Environmental Engineering,
Warsaw University of Technology,
20 Nowowiejska Street,
Warsaw 00-653, Poland
e-mail: michal.kubrak@pw.edu.pl
Hydro and Environmental Engineering,
Warsaw University of Technology,
20 Nowowiejska Street,
Warsaw 00-653, Poland
e-mail: michal.kubrak@pw.edu.pl
Search for other works by this author on:
Paweł Stefanek
Paweł Stefanek
Tailings Management Division,
KGHM Polska Miedź,
52 Polkowicka Street,
Rudna 59-305, Poland
e-mail: pawel.stefanek@kghm.com
KGHM Polska Miedź,
52 Polkowicka Street,
Rudna 59-305, Poland
e-mail: pawel.stefanek@kghm.com
Search for other works by this author on:
Apoloniusz Kodura
Faculty of Building Services,
Hydro and Environmental Engineering,
Warsaw University of Technology,
20 Nowowiejska Street,
Warsaw 00-653, Poland
e-mail: apoloniusz.kodura@pw.edu.pl
Hydro and Environmental Engineering,
Warsaw University of Technology,
20 Nowowiejska Street,
Warsaw 00-653, Poland
e-mail: apoloniusz.kodura@pw.edu.pl
Katarzyna Weinerowska-Bords
Department of Civil and
Environmental Engineering,
Gdansk University of Technology,
11-12 Gabriela Narutowicza Street,
Gdańsk 80-233, Poland
e-mail: kwein@pg.edu.pl
Environmental Engineering,
Gdansk University of Technology,
11-12 Gabriela Narutowicza Street,
Gdańsk 80-233, Poland
e-mail: kwein@pg.edu.pl
Wojciech Artichowicz
Department of Civil and
Environmental Engineering,
Gdansk University of Technology,
11-12 Gabriela Narutowicza Street,
Gdańsk 80-233, Poland
e-mail: wojartic@pg.edu.pl
Environmental Engineering,
Gdansk University of Technology,
11-12 Gabriela Narutowicza Street,
Gdańsk 80-233, Poland
e-mail: wojartic@pg.edu.pl
Michał Kubrak
Faculty of Building Services,
Hydro and Environmental Engineering,
Warsaw University of Technology,
20 Nowowiejska Street,
Warsaw 00-653, Poland
e-mail: michal.kubrak@pw.edu.pl
Hydro and Environmental Engineering,
Warsaw University of Technology,
20 Nowowiejska Street,
Warsaw 00-653, Poland
e-mail: michal.kubrak@pw.edu.pl
Paweł Stefanek
Tailings Management Division,
KGHM Polska Miedź,
52 Polkowicka Street,
Rudna 59-305, Poland
e-mail: pawel.stefanek@kghm.com
KGHM Polska Miedź,
52 Polkowicka Street,
Rudna 59-305, Poland
e-mail: pawel.stefanek@kghm.com
1Corresponding author.
Contributed by the Fluids Engineering Division of ASME for publication in the JOURNAL OF FLUIDS ENGINEERING. Manuscript received October 10, 2018; final manuscript received February 16, 2019; published online April 8, 2019. Assoc. Editor: Matevz Dular.
J. Fluids Eng. Aug 2019, 141(8): 081115 (8 pages)
Published Online: April 8, 2019
Article history
Received:
October 10, 2018
Revised:
February 16, 2019
Citation
Kodura, A., Weinerowska-Bords, K., Artichowicz, W., Kubrak, M., and Stefanek, P. (April 8, 2019). "In Situ Verification of Numerical Model of Water Hammer in Slurries." ASME. J. Fluids Eng. August 2019; 141(8): 081115. https://doi.org/10.1115/1.4042959
Download citation file:
Get Email Alerts
Cited By
Related Articles
Air Entrainment Effects on the Pressure Transients of Pumping Systems With Weir Discharge Chamber
J. Fluids Eng (December,2002)
An Experimental and Numerical Analysis of Water Hammer Phenomenon in Slurries
J. Fluids Eng (December,2017)
Development of a New Simulation Technique Based on the Modal Approximation for Fluid Transients in Complex Pipeline Systems With Time-Variant Nonlinear Boundary Conditions
J. Fluids Eng (June,2007)
A New Model to Simulate Gas Injection in Gas Chamber Pumps
J. Energy Resour. Technol (December,2004)
Related Chapters
Dynamic Behavior of Pumping Systems
Pipeline Pumping and Compression Systems: A Practical Approach
Station Automation
Pipeline System Automation and Control
Spatial Data and Spatial Data Management
Pipeline Geomatics: Practice and Innovation