In the present work, a numerical study is carried out to compare the performance of seven turbulence models on a single pitching blade of cycloidal rotor operating in deep dynamic stall regime at moderate Reynolds number. The investigated turbulence models were: (i) kω-shear stress transport (SST), (ii) kω-SST with γ, (iii) transition SST (γ–Reθ), (iv) scale adaptive simulation (SAS), (v) SAS coupled with transition SST, (vi) SAS with γ, and (vii) detached eddy simulation (DES) coupled with transition kω-SST. The wake vortices evolution and shedding analysis are also carried out for the pitching blade. The performance of the investigated turbulence models is evaluated at various critical points on the hysterias loop of lift and drag coefficients. The predictions of the investigated turbulence models are in good agreement at lower angle of attack, i.e., αu ≤ 20 deg. The detailed quantitative analysis at critical points showed that the predictions of SAS and transition SST-SAS turbulence models are in better agreement with the experimental results as compared to the other investigated models. The wake vortices analysis and fast Fourier transport analysis showed that the wake vortex characteristics of a pitching blade are significantly different than those for the low amplitude oscillating blade at the higher reduced frequency.
Skip Nav Destination
Article navigation
January 2019
Research-Article
Numerical Modeling of Stall and Poststall Events of a Single Pitching Blade of a Cycloidal Rotor
Kuldeep Singh,
Kuldeep Singh
Department of Electromechanical Engineering,
University of Beira Interior,
R. Marquês D'Avila e Bolama,
Covilhã 6201-001, Portugal
e-mail: k.singh@ubi.pt
University of Beira Interior,
R. Marquês D'Avila e Bolama,
Covilhã 6201-001, Portugal
e-mail: k.singh@ubi.pt
Search for other works by this author on:
José Carlos Páscoa
José Carlos Páscoa
Associate Professor
Department of Electromechanical Engineering,
University of Beira Interior,
Covilhã 6201-001, Portugal
e-mail: pascoa@ubi.pt
Department of Electromechanical Engineering,
University of Beira Interior,
R. Marquês D'Avila e Bolama
,Covilhã 6201-001, Portugal
e-mail: pascoa@ubi.pt
Search for other works by this author on:
Kuldeep Singh
Department of Electromechanical Engineering,
University of Beira Interior,
R. Marquês D'Avila e Bolama,
Covilhã 6201-001, Portugal
e-mail: k.singh@ubi.pt
University of Beira Interior,
R. Marquês D'Avila e Bolama,
Covilhã 6201-001, Portugal
e-mail: k.singh@ubi.pt
José Carlos Páscoa
Associate Professor
Department of Electromechanical Engineering,
University of Beira Interior,
Covilhã 6201-001, Portugal
e-mail: pascoa@ubi.pt
Department of Electromechanical Engineering,
University of Beira Interior,
R. Marquês D'Avila e Bolama
,Covilhã 6201-001, Portugal
e-mail: pascoa@ubi.pt
1Corresponding author.
Contributed by the Fluids Engineering Division of ASME for publication in the JOURNAL OF FLUIDS ENGINEERING. Manuscript received January 26, 2018; final manuscript received May 10, 2018; published online June 27, 2018. Assoc. Editor: Philipp Epple.
J. Fluids Eng. Jan 2019, 141(1): 011103 (16 pages)
Published Online: June 27, 2018
Article history
Received:
January 26, 2018
Revised:
May 10, 2018
Citation
Singh, K., and Páscoa, J. C. (June 27, 2018). "Numerical Modeling of Stall and Poststall Events of a Single Pitching Blade of a Cycloidal Rotor." ASME. J. Fluids Eng. January 2019; 141(1): 011103. https://doi.org/10.1115/1.4040302
Download citation file:
Get Email Alerts
Related Articles
Unsteady Flow Field of an Axial-Flow Turbine Rotor at a Low Reynolds Number
J. Turbomach (April,2007)
A Correlation-Based Transition Model Using Local Variables—Part II:
Test Cases and Industrial Applications
J. Turbomach (January,0001)
Control of Vortex Shedding Using a Screen Attached on the Separation Point of a Circular Cylinder and Its Effect on Drag
J. Fluids Eng (July,2017)
Flow Past a Sphere With Surface Blowing and Suction
J. Fluids Eng (December,2007)
Related Proceedings Papers
Related Chapters
Cavitating Structures at Inception in Turbulent Shear Flow
Proceedings of the 10th International Symposium on Cavitation (CAV2018)
Vortex-Induced Vibration
Flow Induced Vibration of Power and Process Plant Components: A Practical Workbook
Introduction
Design and Analysis of Centrifugal Compressors