The effect of uniform surface blowing and suction on the wake dynamics and the drag and lift forces on a sphere is studied using a high-resolution direct numerical simulation technique. The sphere Reynolds number Re, based on its diameter and the freestream velocity, is in the range 1–300. The onset of recirculation in the sphere wake occurs at higher Re, and the transition to nonaxisymmetry and unsteadiness occurs at lower Re in the presence of blowing. The size of the recirculation region increases with blowing, but it nearly disappears in the case of suction. Wake oscillation also increases in the presence of blowing. The drag coefficient in the presence of blowing is reduced compared to that in uniform flow, in the range , whereas it is increased in the presence of suction. The reduction in the wake pressure minimum associated with the enhanced vortical structures is the primary cause for drag reduction in the case of blowing. In the case of suction, it is the increased surface vorticity associated with the reduction of the boundary layer that results into increased drag. The fluctuations in the instantaneous lift and drag coefficients are significant for blowing, and they result from the asymmetric movement of the wake pressure minimum associated with the shedding process.
Skip Nav Destination
e-mail: pbagchi@jove.rutgers.edu
Article navigation
December 2007
Research Papers
Flow Past a Sphere With Surface Blowing and Suction
Prosenjit Bagchi
Prosenjit Bagchi
Department of Mechanical and Aerospace Engineering, Rutgers,
e-mail: pbagchi@jove.rutgers.edu
The State University of New Jersey
, 98 Brett Road, Piscataway, NJ 08854
Search for other works by this author on:
Prosenjit Bagchi
Department of Mechanical and Aerospace Engineering, Rutgers,
The State University of New Jersey
, 98 Brett Road, Piscataway, NJ 08854e-mail: pbagchi@jove.rutgers.edu
J. Fluids Eng. Dec 2007, 129(12): 1547-1558 (12 pages)
Published Online: June 30, 2007
Article history
Received:
December 16, 2006
Revised:
June 30, 2007
Citation
Bagchi, P. (June 30, 2007). "Flow Past a Sphere With Surface Blowing and Suction." ASME. J. Fluids Eng. December 2007; 129(12): 1547–1558. https://doi.org/10.1115/1.2801361
Download citation file:
Get Email Alerts
Cited By
Related Articles
Flow Structure in the Wake of a Rotationally Oscillating Cylinder
J. Fluids Eng (June,2000)
Investigation of Vortex Shedding and Wake-Wake Interaction in a Transonic Turbine Stage Using Laser-Doppler-Velocimetry and Particle-Image-Velocimetry
J. Turbomach (January,2006)
Flow Physics of a Race Car Wing With Vortex Generators in Ground Effect
J. Fluids Eng (December,2009)
The Effect of Uniform Blowing on the Flow Past a Circular Cylinder
J. Fluids Eng (June,2002)
Related Proceedings Papers
Related Chapters
Vortex-Induced Vibration
Flow Induced Vibration of Power and Process Plant Components: A Practical Workbook
Cavitating Structures at Inception in Turbulent Shear Flow
Proceedings of the 10th International Symposium on Cavitation (CAV2018)
Introduction
Design and Analysis of Centrifugal Compressors