Non-isothermal flows with convective heat transfer through a curved duct of square cross section are numerically studied by using a spectral method, and covering a wide range of curvature, $\delta $, $0<\delta \u22640.5$ and the Dean number, Dn, $0\u2264Dn\u22646000$. A temperature difference is applied across the vertical sidewalls for the Grashof number $Gr=100$, where the outer wall is heated and the inner one cooled. Steady solutions are obtained by the Newton-Raphson iteration method and their linear stability is investigated. It is found that the stability characteristics drastically change due to an increase of curvature from $\delta $ = 0.23 to 0.24. When there is no stable steady solution, time evolution calculations as well as their spectral analyses show that the steady flow turns into chaos through periodic or multi-periodic flows if Dn is increased no matter what $\delta $ is. The transition to a periodic or chaotic state is retarded with an increase of $\delta $. Nusselt numbers are calculated as an index of horizontal heat transfer and it is found that the convection due to the secondary flow, enhanced by the centrifugal force, increases heat transfer significantly from the heated wall to the fluid. If the flow becomes periodic and then chaotic, as Dn increases, the rate of heat transfer increases remarkably.

Skip Nav Destination
Research Center for Energy Conversion,
Department of Mechanical Engineering, Faculty of Engineering,
Department of Mechanical Engineering, Faculty of Engineering,

yanase@mech.okayama-u.ac.jp

Article navigation

September 2006

Technical Papers

# Effects of Curvature and Convective Heat Transfer in Curved Square Duct Flows

R. N. Mondal,

R. N. Mondal

Graduate School of Natural Science and Technology,

Okayama University

, Okayama 700-8530, Japan
Search for other works by this author on:

Y. Kaga,

Y. Kaga

Research Center for Energy Conversion,

Doshisha University

, Tataratsu-dani 1-3, Kyo-tanabe city, Kyoto 610-0394, Japan
Search for other works by this author on:

T. Hyakutake,

T. Hyakutake

Department of Mechanical Engineering, Faculty of Engineering,

Okayama University

, Okayama 700-8530, Japan
Search for other works by this author on:

S. Yanase

S. Yanase

Department of Mechanical Engineering, Faculty of Engineering,

yanase@mech.okayama-u.ac.jp
Okayama University

, Okayama 700-8530, Japan
Search for other works by this author on:

R. N. Mondal

Graduate School of Natural Science and Technology,

Okayama University

, Okayama 700-8530, Japan
Y. Kaga

Doshisha University

, Tataratsu-dani 1-3, Kyo-tanabe city, Kyoto 610-0394, Japan
T. Hyakutake

Okayama University

, Okayama 700-8530, Japan
S. Yanase

Okayama University

, Okayama 700-8530, Japanyanase@mech.okayama-u.ac.jp

*J. Fluids Eng*. Sep 2006, 128(5): 1013-1022 (10 pages)

**Published Online:**March 3, 2006

Article history

Received:

June 16, 2005

Revised:

March 3, 2006

Citation

Mondal, R. N., Kaga, Y., Hyakutake, T., and Yanase, S. (March 3, 2006). "Effects of Curvature and Convective Heat Transfer in Curved Square Duct Flows." ASME. *J. Fluids Eng*. September 2006; 128(5): 1013–1022. https://doi.org/10.1115/1.2236131

Download citation file:

### Get Email Alerts

### Cited By

### Related Articles

Transition to Turbulence in Pulsatile Flow Through Heart Valves—A Modified Stability Approach

J Biomech Eng (November,1994)

Heat Transfer on Internal Surfaces of a Duct Subjected to Impingement of a Jet Array with Varying Jet Hole-Size and Spacing

J. Turbomach (January,2006)

Correlations of the Convection Heat Transfer in Annular Channels With Rotating Inner Cylinder

J. Eng. Gas Turbines Power (October,1999)

### Related Proceedings Papers

### Related Chapters

Spectral Analysis of Finite Amplitude Random Wave Loadings

International Conference on Mechanical and Electrical Technology 2009 (ICMET 2009)

Automatic Silence/Sonorant/Non-Sonorant Detection Based on Multi-Resolution Spectral Analysis and Anova Method

International Conference on Instrumentation, Measurement, Circuits and Systems (ICIMCS 2011)

Extended Surfaces

Thermal Management of Microelectronic Equipment, Second Edition