This paper presents and discusses the results of an experimental program that has been made on an air test rig of a radial flow pump. The tested impeller is the so-called SHF impeller. Many experimental data have already been produced (tests in air and in water) on that geometry and these results are still used as databases for the validation of CFD codes. For the present study, an air test rig has been chosen for optical access facilities and measurements were realized with a vaneless diffuser. The 2D Particle Image Velocimetry technique has been used and measurements of flow velocities have been made simultaneously in the outer part of the impeller and in the vaneless diffuser. Measurements have been realized in five planes, in the hub to shroud direction, for various relative flow rates (design and off-design operating conditions). First, the paper focus on the evolutions of the phase averaged velocity charts in the impeller and the diffuser. Limitations of the phase averaging technique clearly appear in the very low partial flow rates and this will be related to previous pressure measurements analysis establishing the occurrence of rotating stall within the impeller for such operating conditions. The paper also proposes an analysis of the rates of fluctuations of the velocity charts and the evolutions in the various measuring planes as the relative flow rate becomes lower.

Issue Section:
Technical Papers
Keywords:
pumps, flow measurement, rotors, stators, velocity measurement, performance evaluation
Topics:
Design, Flow (Dynamics), Fluctuations (Physics), Impellers, Pumps, Radial flow, Vaneless diffusers, Blades, Diffusers
1.
Barrand, J. P., Caignaert, G., Canavelis, R., and Guiton, P., 1984, “Experimental Determination of the Reverse Flow Onset in a Centrifugal Impeller,” Proceedings of the First International Pump Symposium. Texas A&M University.
2.
Barrand, J. P., Caignaert, G., Graeser, J. E., and Rieutord, E., 1985, “Synthe`se de Re´sultats an Air et en eau en vue de la De´tection des De´bits Critiques de Recirculation a` l’entre´e et a` la Sortie de la roue d’une Pompe Centrifuge,” La Houille Blanche No. 5, pp. 405–420.
3.
Caignaert, G., Desmet, B., Maroufi, S., and Barrand, J. P., 1985, “Velocities and Pressure Measurements and Analysis at the Outlet of a Centrifugal Pump,” ASME Paper 85-WA/FE-6.
4.
Caignaert, G., Barrand, J. P, and Desmet, B., 1988, “Recirculation at Impeller Inlet and Outlet of a Centrifugal Pump,” Proceedings of the Institution of Mechanical Engineers, ImechE 1988-5, paper C337-88, pp. 61–68.
5.
Caignaert, G., and Morel, P., 1995, “Mean Pressure Measurements Within a Centrifugal Pump Impeller at Partial Flow Rates,” VDI Berichte, 1186, pp. 405–419.
6.
Caignaert, G., and Patricio, O., 1998, “Pressure Fluctuations Within the Impeller and the Inlet Duct of a Centrifugal Pump,” Hydraulic Machinery and Cavitation, World Scientific, ed, pp. 703–710.
7.
Combes, J. F., and Rieutord, E., 1992, “Numerical and Experimental Analysis of the Flow in a Centrifugal Pump at Nominal and Partial Flow Rate,” ASME paper 92 GT 248, 12 pages.
8.
El Hajem, M., Morel, M., Spettel, F., and Bois, G., 1998, “Etude de l’Ecoulement Moyen en Sortie de roue d’une Pompe Centrifuge (roue SHF),” La Houille Blanche, No. 7, pp. 24–31.
9.
Stanislas, M., Kompenhans, J., and Westerweel, J., 2000, Particle image velocimetry: towards industrial applications, Kluwer Academic Press, Amsterdam.
10.
Sinha
,
M.
, and
Katz
,
J.
,
2000
, “
Quantitative Visualization of the Flow in a Centrifugal Pump With Diffuser Vanes. I: on Flow Structures and Turbulence
,”
ASME J. Fluids Eng.
,
122
, pp.
97
–
107
.
11.
Sinha
,
M.
,
Katz
,
J.
, and
Meneveau
,
Ch.
,
2000
, “
Quantitative Visualization of the Flow in a Centrifugal Pump With Diffuser Vanes. II: Addressing Passage-Averaged and Large-Eddy Simulation Modeling Issues in Turbomachinery Flows
,”
ASME J. Fluids Eng.
,
122
, pp.
108
–
116
.
12.
Myers
,
K. J.
,
Ward
,
R. W.
, and
Bakker
,
A.
,
1997
, “
A Digital Particle Image Velocimetry Investigation of Flow Field Instabilities of Axial-Flow Impellers
,”
ASME J. Fluids Eng.
,
119
, pp.
623
–
632
.
13.
Wuibaut, G., Dupont, P., Caignaert, G., and Stanislas, M., 2000, “Experimental Analysis of Velocities in the Outlet Part of a Radial Flow Pump Impeller and the Vaneless Diffuser Using Particle Image Velocimetry,” XX IAHR Symposium, Charlotte, 6–9 Aug. 2000, paper GU03.
14.
Wuibaut, G., Dupont, P., Bois, G., Caignaert, G., and Stanislas, M., 2001, “Analysis of Flow Velocities Within the Impeller and the Vaneless Diffuser of a Radial Flow Pump,” 4th European Conference on Turbomachinery, Fluid Dynamics and Thermodynamics, 20–23 March, 2001, Firenze, Italy, paper ATI-CST-047/01.
15.
Raffel M., Willert C., and Kompenhans, J., 1998, Particle Image Velocimetry, Springer-Verlag, Berlin Heidelberg, p. 127.
16.
Johnston
,
J. P.
, and
Eide
,
S. A.
,
1976
, “
Turbulent Boundary Layers on Centrifugal Compressors Blades: Prediction of the Effects of Surface Curvature and Rotation
,”
ASME J. Fluids Eng.
,
98
, pp.
374
–
381
.
17.
El Hajem, M., Akhras, A., Morel, R., and Champagne, J. Y., 2001, “Rotor Stator Interactions in a Centrifugal Pump Equipped with a Vaned Diffuser,” 4th European Conference on Turbomachinery, Fluid Dynamics and Thermodynamics, 20–23 Mar. Firenze, Italy.
18.
Ubaldi
,
M.
,
Zunino
,
P.
, and
Cattanei
,
A.
,
1993
, “
A. Relative Flow and Turbulence Measurements Downstream of a Backward Centrifugal Impeller
,”
ASME J. Turbomach.
,
115
, pp.
543
–
551
.
Copyright © 2002
 by ASME
You do not currently have access to this content.