This paper presents results obtained from a combined experimental and computational study of the flow field over a multi-element aerofoil with and without an advanced slat. Detailed measurements of the mean flow and turbulent quantities over a multi-element aerofoil model in a wind tunnel have been carried out using stationary and flying hot-wire (FHW) probes. The model configuration which spans the test section 600mm×600mm, is made of three parts: 1) an advanced (heel-less) slat, 2) a NACA 4412 main aerofoil and 3) a NACA 4415 flap. The chord lengths of the elements were 38, 250 and 83 mm, respectively. The results were obtained at a chord Reynolds number of 3×105 and a free Mach number of less than 0.1. The variations in the flow field are explained with reference to three distinct flow field regimes: attached flow, intermittent separated flow, and separated flow. Initial comparative results are presented for the single main aerofoil and the main aerofoil with a nondeflected flap at angles of attacks of 5, 10, and 15 deg. This is followed by the results for the three-element aerofoil with emphasis on the slat performance at angles of attack α=10, 15, 20, and 25 deg. Results are discussed both for a nondeflected flap δf=0deg and a deflected flap δf=25deg. The measurements presented are combined with other related aerofoil measurements to explain the main interaction of the slat/main aerofoil and main aerofoil/flap both for nondeflected and deflected flap conditions. These results are linked to numerically calculated variations in lift and drag coefficients with angle of attack and flap deflection angle.

Issue Section:
Technical Papers
Keywords:
aerodynamics, turbulence, flow simulation, flow separation, subsonic flow, drag, Turbulent Flow, Flying Hot-Wire, Advanced and Conventional Slats, Multi-Element Aerofoil
Topics:
Airfoils, Flow (Dynamics), Stress, Separation (Technology)
1.
Innes, F., Pearcey, H. H., and Sykes, D. M., 1995, “Improvements in the performance of a three element high lift system by the application of airjet vortex generators,” Proc. Conference High Lift and Separation Control, Royal Aeronautical Society, University of Bath, UK, pp 25.1–25.11.
2.
Moens, F., and Capbern, P., 1995, “Design and testing of leading-edge high-lift device for laminar flow wing applications,” Proc. Conference on High Lift and Separation Control, Royal Aeronautical Society, University of Bath, UK, pp. 7.1–7.13.
3.
Seetharam, H. C., and Wentz, W. H. J., 1977, “A low speed two-dimensional study of flow separation on the GA(W)-1 airfoil with 30-percent chord Fowler flap,” NASA CR-2844.
4.
Olson, L. E., and Orlow, K. L., 1981, “On the structure of turbulent wakes and merging shear layers of multielement aerofoils,” AIAA paper 81-1238.
5.
Biber
,
K.
, and
Zumwalt
,
G. W.
,
1993
, “
Flowfield measurements of a two-element airfoil with large separation
,”
AIAA J.
,
31
, No.
3
, pp.
459
–
464
.
6.
Nakayama
,
A.
,
Kreplin
,
H. P.
, and
Morgan
,
H. L.
,
1990
, “
Experimental investigation of flowfield about a multielement airfoil
,”
AIAA J.
,
28
, No.
1
, pp.
14
–
21
.
7.
Braden, J. A., Whipkey, R. R., Jones, G. S., and Lilley, D. E., 1986, “Experimental study of the separating confluent boundary layer,” NASA CR-3655. also AIAA paper 86-0505.
8.
Savory
,
E.
,
Toy
,
N.
,
Tahouri
, and
Dalley
,
S.
,
1992
, “
Flow regimes in the cove regions between a slat and wing and between a wing and a flap of a multielement aerofoil
,”
Exp. Therm. Fluid Sci.
,
5
, pp.
307
–
316
.
9.
Alemdaroglu, N., 1993, “Experimental investigation of flow around a multielement airfoil,” AGARD-CP-515.
10.
Maddah, S. R., Gough, T., and Bruun, H. H., 2001, “Investigation of slat heel effect on flow field over multi-element aerofoils,” Proc. ASME FEDSM 2001 Conference, New Orleans, USA, session F-252-03.
11.
Jones, J. B. C., 1993, “An optimised slat to maximise performance in both aircraft take-off and landing,” PhD thesis, University of Hertfordshire, UK.
12.
Bruun, H. H., 1995, Hot-wire anemometry, Oxford University Press, Oxford London.
13.
Maddah, S. R., 2000, “Study of the flow field over the multi-element aerofoils,” PhD thesis, Dept. of Mech. and Med. Engineering, Univ. of Bradford.
14.
Coles
,
D.
, and
Wadcock
,
A. J.
,
1979
, “
Flying hot-wire study of flow past an NACA 4412 airfoil at maximum lift
,”
AIAA J.
,
17
, No.
4
, pp.
321
–
329
.
15.
Mahmood, Z., Khan, M. K., Seale, W. J., and Bruun, H. H., 1995a, “Comparison of measured and computed velocity fields over a high lift aerofoil,” Proc. Seventh International Conference on computational methods and experimental measurements, Computational Mechanics Publications, Southampton, UK, Capri, pp 203–211.
16.
Mahmood, Z., Khan, M. K., and Bruun, H. H., 1995b, “Flow over high lift multiple aerofoils,” Proc. of Conference on High Lift and Separation Control, Royal Aeronautical Society.
17.
Smith, A. M. O., 1974, “High lift aerodynamics,” AIAA paper 74-039.
Copyright © 2002
 by ASME
You do not currently have access to this content.