Many engineering and environmental system analyses can benefit from appropriate modeling of turbulent flow in porous media. Through the volumetric averaging of the microscopic transport equations for the turbulent kinetic energy, k, and its dissipation rate, ε, a macroscopic model was proposed for such media (IJHMT, 44(6), 1081-1093, 2001). In that initial work, the medium was simulated as an infinite array of cylindrical rods. As an outcome of the volume averaging process, additional terms appeared in the equations for k and ε. These terms were here adjusted assuming now the porous structure to be modeled as an array of elliptic rods instead. Such an adjustment was obtained by numerically solving the microscopic flow governing equations, using a low Reynolds formulation, in the periodic cell composing the medium. Different porosity and Reynolds numbers were investigated. The fine turbulence structure of the flow was computed and integral parameters were presented. The adjusted model constant was compared to similar results for square and cylindrical rods. It is expected that the contribution herein provide some insight to modelers devoted to the analysis of engineering and a environmental systems characterized by a porous structure saturated by a fluid flowing in turbulent regime.
Skip Nav Destination
Article navigation
December 2001
Technical Papers
On the Mathematical Description and Simulation of Turbulent Flow in a Porous Medium Formed by an Array of Elliptic Rods
Marcos H. J. Pedras,
Marcos H. J. Pedras
Instituto de Pesquisa e Desenvolvimento IP&D, UNIVAP, 12244-000, Sa˜o Jose´ dos Campos, SP, Brazil
Search for other works by this author on:
Marcelo J. S. de Lemos, Mem. ASME
Marcelo J. S. de Lemos, Mem. ASME
Departamento de Energia - IEME, Instituto Tecnolo´gico de Aerona´utica - ITA, 12228-900, Sa˜o Jose´ dos Campos, SP, Brazil
Search for other works by this author on:
Marcos H. J. Pedras
Instituto de Pesquisa e Desenvolvimento IP&D, UNIVAP, 12244-000, Sa˜o Jose´ dos Campos, SP, Brazil
Marcelo J. S. de Lemos, Mem. ASME
Departamento de Energia - IEME, Instituto Tecnolo´gico de Aerona´utica - ITA, 12228-900, Sa˜o Jose´ dos Campos, SP, Brazil
Contributed by the Fluids Engineering Division for publication in the JOURNAL OF FLUIDS ENGINEERING. Manuscript received by the Fluids Engineering Division January 18, 2001; revised manuscript received August 8, 2001. Associate Editor: L. Mondy.
J. Fluids Eng. Dec 2001, 123(4): 941-947 (7 pages)
Published Online: August 8, 2001
Article history
Received:
January 18, 2001
Revised:
August 8, 2001
Citation
Pedras, M. H. J., and de Lemos, M. J. S. (August 8, 2001). "On the Mathematical Description and Simulation of Turbulent Flow in a Porous Medium Formed by an Array of Elliptic Rods ." ASME. J. Fluids Eng. December 2001; 123(4): 941–947. https://doi.org/10.1115/1.1413244
Download citation file:
Get Email Alerts
Related Articles
Turbulent Flow Hydrodynamic Experiments in Near-Compact Heat Exchanger Models With Aligned Tubes
J. Fluids Eng (November,2004)
A Correlation for Interfacial Heat Transfer Coefficient for Turbulent Flow Over an Array of Square Rods
J. Heat Transfer (May,2006)
Closure to “Discussion of ‘Alternative Models of Turbulence in a Porous Medium, and Related Matters’ ” (2001, ASME J. Fluids Eng., 123, p. 931)
J. Fluids Eng (December,2001)
A Methodology for Simulations of Complex Turbulent Flows
J. Fluids Eng (December,2002)
Related Proceedings Papers
Related Chapters
Assessment of Flow Aggressiveness at an Ultrasonic Horn Cavitation Erosion Test Device by PVDF Pressure Measurements and 3D Flow Simulations
Proceedings of the 10th International Symposium on Cavitation (CAV2018)
Turbulence-Induced Vibration in Parallel Flow
Flow Induced Vibration of Power and Process Plant Components: A Practical Workbook
Extended Surfaces
Thermal Management of Microelectronic Equipment