An experimental investigation has been performed to determine the effect of variation in the length-to-diameter ratios on the discharge characteristics of saturated liquids passing through square edge orifices subjected to low pressure differentials. Experiments were performed to confirm reported results for sharp edge orifices and for round edge orifices with appreciable ratios of inlet corner radius to orifice diameter.

1.
Bailey, B. F., 1951, “Metastable Flow of Saturated Water,” Trans. ASME, Paper No. 51-SA-55, pp. 1109–1116.
2.
Behbahani
A. I.
,
Weisman
J.
, and
Shen
P. K.
,
1989
, “
Apparent Contradictions in Observations of the Discharge of Two-Phase Mixtures Through Restrictions
,”
Chem. Eng. Comm.
, Vol.
77
, pp.
171
181
.
3.
Benjamin, M. W., and Miller, J. G., 1941, “The Flow of Saturated Water Through Throttling Orifices,” Trans. ASME, pp. 419–429.
4.
Blevins, R. D., 1992, Applied Fluid Dynamics Handbook, Krieger Publishing, Malabar, Florida.
5.
Carey, V. P., 1992, Liquid-Vapor Phase-Change Phenomena, Hemisphere Publishing, Washington.
6.
Danforth, J. L., 1941, Flow of Hot Water Through a Rounded Orifice Master of Science Thesis from the Massachusetts Institute of Technology.
7.
Fox
T. A.
, and
Stark
J.
,
1989
, “
Characteristics of Miniature Short-Tube Orifice Flows
,”
Part C: Journal of Mechanical Engineering Science
, Proc. Instn. Mech. Engrs., Vol.
203
, pp.
351
358
.
8.
Idelchik, I. E., 1986, Handbook of Hydraulic Resistance 2nd ed., Hemisphere Publishing Corporation, Washington.
9.
Lichtarowicz
A.
,
Duggins
R. K.
, and
Markland
E.
,
1965
, “
Discharge Coefficients for Incompressible Non-Cavitating Flow Through Long Orifices
,”
ASME Journal of Mechanical Engineering Science
, Vol.
7
, No.
2
, pp.
210
219
.
10.
McGreehan
W. F.
, and
Schotsch
M. J.
,
1988
, “
Flow Characteristics of Long Orifices with Rotation and Corner Radiusing
,” ASME
Journal of Turbomachinery
, Vol.
110
, pp.
213
217
, April 1988.
11.
Miller, R. W., 1983, Flow Measurement Engineering Handbook, McGraw-Hill, New York.
12.
Monroe, E. S. Jr., 1956, “Flow of Saturated Boiler Water Through Knife-Edge Orifices in Series,” Trans. ASME, Paper No. 54-A-118, pp. 373–377.
13.
Numachi
F.
,
Yamabe
M.
, and
Oba
R.
,
1960
, “
Cavitation Effect on the Discharge Coefficient of the Sharp-Edge Orifice Plate
,” ASME
Journal of Basic Engineering
, Vol.
82
, pp.
1
11
, March.
14.
Rohloff, T. J., 1995, Discharge of Saturated liquid Through Orifices Subjected to Low Pressure Differentials, Master of Science Thesis from UCLA.
15.
Romig
R. P.
,
Rothfus
R. R.
, and
Kermode
R. I.
,
1966
, “
Partial Vaporization in Orifices and Valves
,”
Industrial and Engineering Chemistry Process Design and Development
, Vol.
5
, No.
3
, July, pp.
342
350
.
16.
Uchida, H., and Nariai, H., 1966, “Discharge of Saturated Water Through Pipes and Orifices,” Proc. of the Third International Heat Transfer Conference, Vol. 5, pp. 1–12.
This content is only available via PDF.
You do not currently have access to this content.