An experimental study of the laminar-to-turbulent transition and resulting hydrodynamic forces on a body of revolution with a long, favorable pressure gradient forebody (i.e., where pressure is dropping and the flow accelerating) is reported. Over a substantial range of body velocity and angle of attack the favorable pressure gradient is shown to postpone transition to the point of laminar separation, and this extended laminar region results in a much lower hydrodynamic drag than is characteristic of an all-turbulent body. The intermittency of the boundary layer and the propagation characteristics of turbulent spots in the extended favorable pressure gradient region are quantified by hot film probes mounted flush with the body surface. The sensitivity of the boundary layer transition to three-dimensional surface roughness elements located in tandem (along a streamline) is also quantified. A number of such elements in tandem causes transition at a lower Reynolds number than would a single element of the same size, this effect becoming more pronounced with increasing number of roughness elements and decreasing space between them.
Skip Nav Destination
Article navigation
June 1984
Research Papers
Laminar-To-Turbulent Transition on a Body of Revolution With an Extended Favorable Pressure Gradient Forebody
R. J. Hansen,
R. J. Hansen
Naval Research Laboratory, Washington, D.C. 20375
Search for other works by this author on:
J. G. Hoyt
J. G. Hoyt
U.S. Naval Academy, Annapolis, Md.
Search for other works by this author on:
R. J. Hansen
Naval Research Laboratory, Washington, D.C. 20375
J. G. Hoyt
U.S. Naval Academy, Annapolis, Md.
J. Fluids Eng. Jun 1984, 106(2): 202-210 (9 pages)
Published Online: June 1, 1984
Article history
Received:
June 27, 1983
Online:
October 26, 2009
Citation
Hansen, R. J., and Hoyt, J. G. (June 1, 1984). "Laminar-To-Turbulent Transition on a Body of Revolution With an Extended Favorable Pressure Gradient Forebody." ASME. J. Fluids Eng. June 1984; 106(2): 202–210. https://doi.org/10.1115/1.3243103
Download citation file:
Get Email Alerts
Related Articles
Forcing Boundary-Layer Transition on a Single-Element Wing in Ground Effect
J. Fluids Eng (October,2017)
Calculation of High-Lift Cascades in Low Pressure Turbine Conditions Using a Three-Equation Model
J. Turbomach (July,2011)
The Influence of Technical Surface Roughness Caused by Precision Forging on the Flow Around a Highly Loaded Compressor Cascade
J. Turbomach (July,2000)
Heat Transfer Through a Pressure-Driven Three-Dimensional Boundary Layer
J. Heat Transfer (May,1991)
Related Proceedings Papers
Related Chapters
Cavitating Structures at Inception in Turbulent Shear Flow
Proceedings of the 10th International Symposium on Cavitation (CAV2018)
Introduction
Design and Analysis of Centrifugal Compressors
Boundary Layer Analysis
Centrifugal Compressors: A Strategy for Aerodynamic Design and Analysis