Numerical Simulation on Proppant Transport in Fracture Junctions Affected by the Fracture Scale

The proppant distribution significantly affects the conductivity of fracture networks. However, the law of proppant transport in fracture networks is still unclear, and the influence of fracture scale on the proppant distribution has not been determined. Thus, in the present study, the influence of fracture scale was investigated, and the influences of approaching angle and width ratio on fluid split ratio were analyzed. An Eulerian–Eulerian model was utilized to simulate suspended proppant and bed load proppant migration in fracture junctions. Then, a sensitivity analysis was carried out to evaluate the parameters that may affect the proppant distribution pattern, such as injection velocity, fluid viscosity, and proppant density. The results show that the approaching angle and width ratio significantly influence the fluid split ratio in a small-scale fracture. Moreover, the effect of the approaching angle decreases with an increase in the fracture scale. The split ratio of suspended proppant increases with increasing sand ratio, fluid split ratio, and width ratio. The split ratio of bed load proppant increases with increasing injection rate, fluid viscosity, width ratio, fluid split ratio, and decreasing proppant diameter. In small-scale fracture junctions, the approaching angle affects the split ratio of suspended proppant or bed load proppant by influencing the fluid split ratio; however, the effect is inconspicuous in large-scale fractures. The increase in fluid split ratio with the fracture scale leads to an increase in the split ratio of suspended proppant or bed load proppant.