Inducers, which are classified as axial flow pumps with helical path blades, are used within rotary gas separators commonly used in electrical submersible pump installations. A two-phase flow model has been developed to study the inducer performance, focusing on head generation. The proposed model is based on a meridional flow solution technique and utilizes a two-fluid approach. The model indicates that head degradation due to gas presence is a function of flow pattern. The effect of flow pattern diminishes when the void fraction is greater than 15 percent since the centrifugal force dominates the interfacial drag force. In this case, the two-phase flow can be approximated as a homogeneous mixture. The model also suggests that a liquid displacement correction is needed when phase segregation occurs inside the inducer. The new model significantly improves the ability to predict separation efficiency of a rotary gas separator over existing models. Hydrocarbon-air and water-air experimental data were gathered to validate the new model.
Issue Section:
Technical Papers
Topics:
Blades,
Flow (Dynamics),
Porosity,
Pumps,
Two-phase flow,
Modeling,
Fluids,
Displacement,
Momentum
1.
Ross
, C. C.
, and Banerian
, G.
, 1956
, “Some Aspects of High Suction Specific Speed Inducers
,” Trans. ASME
, 78
(8
), pp. 1715
–1721
.2.
Acosta, A. J., 1958, “An Experimental Study of Cavitating Inducers,” Proc. Second Symposium on Naval Hydrodynamics, Washington, D.C., pp. 553–557.
3.
Rains
, D. A.
, 1958
, “Head Flow Characteristics of Axial Flow Inducers
,” Jet Propul., August, 557–558.4.
Lakshminarayana, B., 1974, “Experimental and Analytical Investigation of Flow Through a Rocket Pump Inducer,” NASA SP 304, Part II, pp. 690–731.
5.
Lakshminarayana, B., 1978, “On the Shear Pumping Effect in Rocket Pump Inducers,” book chapter in Pump-Analysis, Design and Application, 1, Worthington Pump Inc., pp. 49–68.
6.
Lakshminarayana
, B.
, 1982
, “Fluid Dynamics of Inducers—A Review
,” J. Fluids Eng.
, 104
, pp. 411
–427
.7.
ESP, Inc., “Technical Brochure.”
8.
Alhanati, F. J. S., 1993, “Bottomhole Gas Separation Efficiency in Electrical Submersible Pump Installations,” Ph.D. dissertation, The University of Tulsa, Tulsa, OK.
9.
Mirolyubov, I. V., 1959, “Calculations of the Characteristics of Axial Flow Force Pumps,” Aviattsionnaya Teknika, 1, pp. 81–88 (English translation AFSC, FTD TT 63-418).
10.
Dumov, V. I., 1962, “Calculation of Pressure Head Characteristics of Axial Helical Impellers,” Taploenergetika, 11, pp. 23–27 (English translation AFSC, FTD TT 63-407).
11.
Soltis, R. F., Anderson, D. A., and Sandercock, D. M., 1962, “Investigation of the Performance of a 78° Flat Plate Helical Inducer,” NASA Technical Note D-1170.
12.
Cooper
, P.
, and Bosch
, H.
, 1966
, “Three Dimensional Analysis of Inducer Fluid Flow
,” NASA Contract Rep. NASA CR–54836, TRW ER-6673A.13.
Anand
, A. K.
, Gorton
, C. A.
, Lakshminarayana
, B.
, and Yamaoka
, H.
, 1973
, “Investigation of Boundary Layer and Turbulence Characteristics Inside the Passages of an Axial Flow Inducer
,” NASA Contract Rep. NASA CR–121248, pp.1–220.14.
Poncet
, A.
, and Lakshminarayana
, B.
, 1973
, “Investigations of Three Dimensional Flow Characteristics in a Three Bladed Rocket Pump Inducer
,” NASA Contract Rep. NASA CR–2290. 15.
Lakshminarayana
, B.
, and Gorton
, C. A.
, 1977
, “Three-Dimensional Flow Field in Rocket Pump Inducers, Part 2: Three Dimensional Viscid Flow Analysis and Hot Wire Data on Three Dimensional Mean Flow and Turbulence Inside the Rotor Passage
,” ASME J. Eng. Power
, 98
(2
), pp. 176
–186
.16.
Gorton
, C. A.
, and Lakshminarayana
, B.
, 1980
, “Analytical and Experimental Study of the Three-Dimensional Mean Flow and Turbulence Characteristics Inside the Passage of an Axial Flow Inducer
,” NASA Contract Rep. NASA CR–3333, pp. 1–70.17.
Katsanis, T., 1964, “Use of Arbitrary Quasi-Orthogonals for Calculating Flow Distribution in the Meridional Plane of a Turbomachine,” NASA TN D-2546.
18.
Erler, S. R., Pervaiz, M. M., and Pratt & Wittney, 1995, “Three-Dimensional Computational Fluid Dynamics Analysis Applied To a Rocket Turbopump Inducer,” FED-Vol 227, Numerical Simulations in Turbomachinery, ASME.
19.
Moore, J. G., and Moore, J., 1997, “Influence of Reynolds Number on the Flow and Performance of Rocket Pump Inducer,” paper no. FEDSM97-3357 presented at the ASME Fluids Engineering Division Summer Meeting, June 22–26.
20.
Furuya
, O.
, 1985
, “An Analytical Model for Prediction of Two-Phase (Noncondensable) Flow Pump Performance
,” J. Fluids Eng.
, 107
, pp. 139
–147
.21.
Hench
, J. E.
, and Johnston
, J. P.
, 1972
, “Two-Dimensional Diffuser Performance With Subsonic, Two-Phase, Air-Water Flow
,” J. Basic Eng., March, pp. 105–121.22.
Sachdeva, R., 1988, “Two Phase Flow through Electrical Submersible Pumps,” Ph.D. dissertation, The University of Tulsa, Tulsa, OK.
23.
Minemura
, K.
, Uchiyama
, T.
, Shoda
, S.
, and Egashira
, K.
, 1998
, “Prediction of Air-Water Two-Phase Flow Performance of a Centrifugal Pump Based on One-Dimensional Two-Fluid Model
,” ASME J. Fluids Eng.
, 120
, pp. 327
–334
.24.
Lackner, G., 1997, “The Effect of Viscosity on Downhole Gas Separation in a Rotary Gas Separator,” Ph.D. dissertation, The University of Tulsa, Tulsa, OK.
25.
Harun, A. F., 1999, “The Effect of Inducer Performance on the Efficiency of the ESP Rotary Gas Separator,” Ph.D. dissertation, The University of Tulsa, Tulsa, OK.
26.
Zuber, N., and Hench, J. E., 1962, “Steady State and Transient Void Fraction of Bubbling systems and Their Operating Limits (Part I, Steady State Operation),” GE Report No. 62GL100.
27.
Minemura, K., and Uchiyama, T., 1994, “Numerical Prediction of Two-Phase Flow Pump Performance by a Bubbly Flow Model with Fixed Cavity,” Proc. German-Japanese Symposium on Multi-Phase Flow, K fK-5389, pp. 403–417.
28.
Bosch, H. B., Cooper, P., and Stoermer, W. P., 1963, “Advanced Inducer Study,” TRW ER-5288, May.
29.
Schlichting, H., 1955, “Boundary Layer Theory,” McGraw-Hill, New York.
30.
Lakshminarayana
, B.
, Jabbari
, A.
, and Yamaoka
, H.
, 1972
, “Turbulent Boundary Layer on a Rotating Helical Blade
,” J. Fluid Mech.
, 51, part 3
, pp. 545
–569
.31.
Manzano-Ruiz, J. J., 1980, “Experimental and Theoretical Study of Two-Phase Flow in Centrifugal Pumps,” Ph.D. dissertation, Massachusetts Institute of Technology, Cambridge, MA.
32.
Murakami
, M.
, and Minemura
, K.
, 1976
, “Effects of Running Clearance of Semi-Open Impeller Pumps Under Air-Admitting Conditions
,” Bull. JSME
, 19
(136
), October
October
.33.
Caetano, E. F., 1985, “Upward Vertical Two-Phase Flow Through An Annulus,” Ph.D. dissertation, The University of Tulsa, Tulsa, OK.
34.
Alhanati, F. J. S., and Doty, D. R., 1994, “A Simple Model for the Efficiency of Rotary Separators,” Paper SPE No. 28525 presented at the SPE 69th Annual Technical Conference and Exhibition held in New Orleans, LA, U.S.A., 25–28 September.
35.
Harun
, A. F.
, Prado
, M. G.
, Shirazi
, S. A.
, and Doty
, D. R.
, 2002
, “An Improved Model for Predicting Separation Efficiency of a Rotary Gas Separator in ESP Systems
,” SPE Prod. Facil.
, May
May
.36.
Sambangi, S. R., 1994, “Gas Separation Efficiency in Electrical Submersible Pump Installations with Rotary Gas Separators,” M.S. thesis, The University of Tulsa, Tulsa, OK.
37.
Lackner
, G. A.
, Alhanati
, F. J. S.
, Shirazi
, S. A.
, Doty
, D. R.
, and Schmidt
, Z.
, 1998
, “Numerical Simulation of Gas-Liquid Flow Inside A Downhole Centrifuge
,” ASME J. Energy Resour. Technol.
, 120
, pp. 41
–48
.38.
Lackner
, G. A.
, Doty
, D. R.
, Shirazi
, S. A.
, and Schmidt
, Z.
, 2002
, “Effect of Viscosity on Downhole Gas Separation in a Rotary Gas Separator
,” SPE Prod. Facil.
, August
August
.Copyright © 2004
by ASME
You do not currently have access to this content.
