The flow behavior and heat transfer due to free air jet impingement on pin fin heat sinks was experimentally studied. Flow velocities and tip clearance ratios were varied from 2to20ms and 0 to 1, respectively. The stagnation pressure recovered at the center of the heat sink was higher for tall pins than for short pins. The pressure loss coefficient showed little dependence on Re, increased with increasing pin density and pin diameter, and decreased with increasing pin height and clearance ratio. The overall base-to-ambient thermal resistance decreased with increasing Re number, pin density, and pin diameter.

1.
Shaukatullah
,
H.
,
Storr
,
W. R.
,
Hansen
,
B. J.
, and
Gaynes
,
M. A.
, 1996, “
Design and Optimization of Pin Fin Heat Sinks for Low Velocity Applications
,”
Proceedings of the 12th IEEE SEMI-THERM Symposium
,
IEEE
,
Austin
, pp.
151
163
.
2.
Dogruoz
,
M. B.
,
Urdaneta
,
M.
, and
Ortega
,
A.
, 2005, “
Experiments and Modeling of the Hydraulic Resistance and Heat Transfer of In-line Square Pin Fin Heat Sinks with Top By-pass Flow
,”
Int. J. Heat Mass Transfer
0017-9310,
48
, pp.
5058
5071
.
3.
Maudgal
,
V. K.
, and
J. E.
Sunderland
, 1997, “
An Experimental Study of Forced Convection Heat Transfer from In-line Pin-Fin Arrays
,”
Proceedings of the 13th IEEE SEMI-THERM Symposium
,
IEEE
,
New York
, pp.
149
157
.
4.
Martin
,
H.
, 1977, “
Heat and Mass Transfer Between Impinging Gas Jets and Solid Surfaces
,”
Advances in Heat Transfer
,
Academic
,
Orlando
, Vol.
13
, pp.
1
60
.
5.
Amano
,
R. S.
, 2000, “
Electronic Cooling Technology with the Use of Turbulent Impinging Jets
,”
Proceedings of the 2000 International Conference on Thermal Mechanics and Thermomechanical Phenomena in Electronic Systems, (ITHERM)
,
Las Vegas, Nevada
, pp.
339
346
.
6.
Guarino
,
J. R.
, and
Manno
,
V. P.
, 2001 “
Characterization of Laminar Jet Impingement Cooling in Portable Computer Applications
,”
Proceedings of the 17th IEEE SEMI-THERM Symposium
,
IEEE
,
San Jose, California
, pp.
1
11
.
7.
Jung
,
H. H.
, and
Maveety
,
J. G.
, 2000, “
Pin Fin Heat Sink Modeling and Characterization
,”
Proceedings of the 16th IEEE SEMI-THERM Symposium
,
IEEE
,
San Jose, California
, pp.
260
265
.
8.
Brignoni
,
L. A.
, and
Garimella
,
S. V.
, 1999, “
Experimental Optimization of Confined Air Jet Impingement on a Pin Fin Heat Sink
,”
IEEE Trans. Compon. Packag. Technol.
1521-3331,
22
, pp.
399
404
.
9.
El-Sheikh
,
H. A.
, and
Garimella
,
S. V.
, 2000, “
Enhancement of Air Jet Impingement Heat Transfer Using Pin-Fin Heat Sinks
,”
IEEE Trans. Compon. Packag. Technol.
1521-3331,
23
, pp.
300
308
.
10.
Moffat
,
R. J.
, 1988, “
Describing the Uncertainties in Experimental Results
,”
Exp. Therm. Fluid Sci.
0894-1777,
1
, pp.
3
17
.
11.
Danek
,
C. J.
, and
Moffat
,
R. J.
, 1995, “
Heat Transfer under Impinging Jets at Very Close Jet-to-Target Spacings
,” Report No. HMT-50, Thermosciences Division, Department of Mechanical Engineering,
Stanford University
.
12.
TAS—Thermal Analysis System
, 2001,
Harvard Thermal Inc.
,
Harvard, Massachusetts
, USA.
13.
Issa
,
J. S.
, 2002, “
Experimental Study of the Flow and Heat Transfer of Square Jet Impinging on Pin Fin Heat Sinks
,” M.S. thesis, The University of Arizona, Tucson.
14.
Figliola
,
R. S.
, and
Beasley
,
D. E.
, 1995,
Theory and Design for Mechanical Measurements
,
Wiley
,
New York
, pp.
125
169
.
15.
Incropera
,
F. P.
, and
DeWitt
,
D. P.
, 1996,
Fundamentals of Heat and Mass Transfer
,
Wiley
,
New York
, pp.
110
134
.
This content is only available via PDF.
You do not currently have access to this content.