Surface Nusselt numbers, pressure coefficients, and flow visualizations are presented which are measured as a turbulent jet, with a fully developed velocity profile, impinges on the cylindrical pedestal and on the surrounding flat surface. Thermochromic liquid crystals and shroud-transient techniques are used to measure spatially resolved surface temperature distributions, which are used to deduce local Nusselt numbers. Dimensionless pedestal heights $H/D$ are 0, 0.5, 1.0, and 1.5, the jet Reynolds number Re is 23,000, and the surface distance to nozzle diameter $L/d$ ranges from 2 to 10. Local Nusselt numbers drastically increase with a radial distance away from the stagnation point on top of the pedestal for $H/D$ values of 0.5, 1.0, and 1.5. These are partially due to the small flow recirculation zones present on top of the pedestal, and mixing associated with the separation of flow streamlines near the edge of the upper surface on the pedestal. Local Nusselt numbers are also augmented at flat surface locations corresponding to positions where shear layers reattach downstream of the pedestal. In general, augmentation magnitudes become more pronounced as $H/D$ becomes smaller because of greater vortex influences. Corresponding local Nusselt numbers, beneath shear layer reattachment locations for H/D=0.5, are 35 to 80% higher than values measured at the same flat surface locations when no pedestals are employed.

1.
Fedorov
,
A. G.
, and
Viskanta
,
A.
,
1997
, “
A Numerical Simulation of Conjugate Heat Transfer in an Electronic Package Formed by Embedded Discrete Heat Sources in Contact With Porous Heat Sink
,”
ASME Trans. J. Electron. Packag.
,
119
, pp.
8
16
.
2.
Weiss
,
J.
,
Fortner
,
P.
,
Pearson
,
B.
,
Watson
,
K.
, and
Monroe
,
T.
,
1989
, “
Modeling Air Flow in Electronic Package
,”
Mech. Eng. (Am. Soc. Mech. Eng.)
, pp.
56
58
.
3.
Copeland
,
D.
,
1996
, “
Single-Phase and Boiling Cooling of Small Pin Fin Arrays of Multiple Nozzle Jet Impingement
,”
ASME Trans. J. Electron. Packag.
,
118
, pp.
21
26
.
4.
Sparrow
,
E. M.
, and
Larson
,
E. D.
,
1982
, “
Heat Transfer From Pin-Fins Situated in an Oncoming Longitudinal Flow Which Turns to Crossflow
,”
Int. J. Heat Mass Transfer
,
25
(
5
), pp.
603
614
.
5.
Wadsworth, D. C., 1989, “Cooling of a Multichip Electronic Module by Means of Confined Two-Dimensional Jets of Dielectric Liquid,” M.S. thesis, Purdue University, IN.
6.
Sullivan, P. F., Ramadhyani, S., and Incropera, F. P., 1992, “Extended Surfaces to Enhanced Impingement Cooling With Single Circular Liquid Jets,” ASME paper no. EEP-1-1, Proceedings of the ASME/JSME Joint Conference on Electronic Packaging, San Jose, CA, pp. 207–216.
7.
Sullivan, P. F., Ramadhyani, S., and Incropera, F. P., 1992, “Use of Smooth and Roughened Spreader Plates to Enhance Impingement Cooling With Single Circular Liquid Jets,” ASME paper no. HTD-206-2, National Heat Transfer Conference, San Diego, CA, pp. 103–110.
8.
Teuscher, K. L., 1992, “Packaging Methods for Jet Impingement Cooling of an Array of Discrete Heat Sources,” M.S. thesis, Purdue University, IN.
9.
Baughn
,
J. W.
,
Mesbah
,
M.
, and
Yan
,
X.
,
1993
, “
Measurements of Local Heat Transfer for an Impinging Jet on a Cylindrical Pedestal
,”
ASME-Turbulent Enhancement Heat Transf.
,
HTD-239
, pp.
57
62
.
10.
Parneix
,
S.
,
Behnia
,
M.
, and
Durbin
,
P. A.
,
1999
, “
Predictions of Turbulent Heat Transfer in an Axisymmetric Jet Impinging on a Heated Pedestal
,”
ASME Trans. J. Heat Transfer
,
121
, pp.
43
49
.
11.
Dunne, S. T., 1983, “A Study of Flow and Heat Transfer in Gas Turbine Cooling Passages,” Ph.D. thesis, Oxford University, UK.
12.
Kline
,
S. J.
, and
McKlintock
,
F. A.
,
1953
, “
Describing Uncertainties in Single Sample Experiments
,”
Mech. Eng. (Am. Soc. Mech. Eng.)
,
75
, pp.
3
8
.
13.
Rajaratnam, N., 1976, Turbulent Jet, Elsevier Scientific Publishing Corporation, The Netherlands.
14.
Lee
,
D. H.
,
Song
,
J.
, and
Jo
,
M. C.
,
2004
, “
The Effects of Nozzle Diameter on Impinging Jet Heat Transfer and Fluid Flow
,”
ASME J. Heat Transfer
,
126
, pp.
554
557
.
15.
Baughn
,
J. W.
, and
Shimizu
,
S.
,
1989
, “
Heat Transfer Measurement From a Surface With Uniform Heat Flux and an Impinging Jet
,”
ASME Trans. J. Heat Transfer
,
111
, pp.
1096
1098
.
16.
Gardon, R., and Cobonpue, J., 1962, “Heat Transfer Between a Flat Plate and Jets in Air Impinging on It,” Int. Development Heat Transfer, pp. 454–459.