SOFC numerical simulations and experiments are a low cost method in achieving adequate performance to penetrate the market. Most of the efforts are at the present focused on components, single cells and stack performances and reliability improvements, while, at the same time, a lot of work is needed for optimal system configuration design. Simulation and experimental results conducted on a system level must provide a goal and scope of the single components system research, including fuel processing, fuel cells and all the balance of plant (BoP) components. In the present work a preliminary numerical simulation of a SOFC system is conducted, in order to establish the optimal stack size for minimal cost of electricity (CoE) achievements.
1.
Achenbach
, E.
, 1994, “Three-dimensional and Time-dependent Simulation of a Solid Oxide Fuel Cell Stack
,” J. Power Sources
0378-7753, 49
, pp. 333
–348
.2.
Costamagna
, P.
, and Honegger
, K.
, 1998, “Modeling of Solid Oxide Heat Exchanger Integrated Stacks and Simulation at High Fuel Utilization
,” J. Electrochem. Soc.
0013-4651, 145
(11
), pp. 3995
–4007
.3.
Bessette
, N. F.
, Wepfer
, W. J.
, and Winnick
, J.
, 1995, “A Mathematic Model of a Solid Oxide Fuel Cell
,” J. Electrochem. Soc.
0013-4651, 142
(11
), pp. 3780
–3792
.4.
Bessette
, N. F.
, and Wepfer
, W. J.
, 1996, “Prediction of On-design and Off-design for a Solid Oxide Fuel Cell Power Module
,” Energy Convers. Manage.
0196-8904, 37
(3
), pp. 281
–293
.5.
Arato
, E.
, and Costa
, P.
, 1992, “Mathematic Modeling of Monolithic SOFC
,” Stack Design Tool, an International Energy Agency Task Report, Berne, November 1992.6.
Ferguson
, J. R.
, 1992, “SOFC Two Dimensional Unit Cell Modeling
,” Stack Design Tool, an International Energy Agency Task Report, Berne, November 1992.7.
Haynes
, C.
, 2002, “Simulating Process Settings for Unslaved SOFC Response to Increases in Load Demand
,” J. Power Sources
0378-7753, 109
, pp. 365
–376
.8.
Petruzzi
, L.
, Cocchi
, S.
, and Fineschi
, F.
, 2003, “A Global Thermoelectrochemical SOFC System Design and Engineering
,” J. Power Sources
0378-7753, 118
, pp. 96
–107
.9.
Bossel
, U. G.
, 1992, “Performance Potentials of Solid Oxide Fuel Cell Configurations
,” EPRI TR-101109, Project 1676-15, Final Report, October 1992.10.
Padulles
, J.
, Ault
, G. W.
, and McDonald
, J. R.
, 2000, “An Integrated SOFC Plant Dynamic Model for Power Systems Simulation
,” J. Power Sources
0378-7753, 86
, pp. 495
–500
.11.
Haynes
, C.
, and Wepfer
, W.
, 2000, “Design for Power of a Commercial Grade Tubular Solid Oxide Fuel Cell
,” Energy Convers. Manage.
0196-8904, 41
, pp. 1123
–1139
.12.
Harnish
, U.
, Roos
, M.
, Batawi
, E.
, Baumgartner
, T.
, and Schuler
, A.
, 2002, “Numerical Simulation of HEXIS SOFC Systems
,” Proc. 5th European Solid Oxide Fuel Cell Forum
, J.
Huijsmans
ed., Lucerne
, Switzerland, Vol. 2
, pp. 953
–960
.13.
Costamgna
, P.
, Magistri
, L.
, and Massardo
, A. F.
, 2001, “Design and Part-load Performance of a Hybrid System Based on a Solid Oxide Fuel Cell Reactor and a Micro Gas Turbine
,” J. Power Sources
0378-7753, 96
, pp. 352
–368
.14.
Chan
, S. H.
, Ho
, H. K.
, and Tian
, H. Y.
, 2003, “Multi-level of a SOFC-gas Turbine Hybrid System
,” Int. J. Hydrogen Energy
0360-3199, 28
, pp. 889
–900
.15.
Tanaka
, K.
, Wen
, C.
, and Yamada
, K.
, 2000, “Design and Evaluation of Combined Cycle System with Solid Oxide Fuel Cell and Gas Turbine
,” Fuel
0016-2361, 79
, pp. 1493
–1507
.16.
Chan
, S. H.
, and Tian
, H. Y.
, 2003, “Modeling for Part-load Operation of a Solid Oxide Fuel Cell-gas Turbine Hybrid Power Plant
,” J. Power Sources
0378-7753, 114
, pp. 213
–227
.17.
Riensche
, E.
, Stimming
, U.
, and Unverzagt
, G.
, 1998, “Optimization of a 200kW SOFC Cogeneration Power Plant. Part I: Variation of Process Parameters
,” J. Power Sources
0378-7753, 73
, pp. 251
–256
.18.
Khandkar
, A.
, Hartvigsen
, J.
, and Elangovan
, S.
, 1999, “A Techno-economic Model for SOFC Power Systems
,” Proc. 12th International Conference on Solid State Ionics
, June 6–12, 1999, Thessaloniki
, Greece.19.
Bove
, R.
, Lunghi
, P.
, and Sammes
, N. M.
, 2005, “SOFC Mathematic Model for Systems Simulations. Part Two: Definition of an Analytical Model
,” Int. J. Hydrogen Energy
0360-3199 30
, pp. 189
–200.20.
Strakey
, J. P.
, 2002, “SECA Program Overview
,” Proc. of the Third SECA Annual SECA Workshop
, March 21–22, 2002, Washington
, D.C., pp. 2
–11
.21.
EG&G Technical Service
, 2002, “Fuel Cell Handbook Sixth edition
,” U.S. Department of Energy, Office of Fossil Energy, National Energy Technology Laboratory, Chap. 1, pp. 35
–36
.Copyright © 2005
by American Society of Mechanical Engineers
You do not currently have access to this content.