Skip Nav Destination
Design & Analysis of ASME Boiler and Pressure Vessel Components in the Creep Range
ISBN:
9780791802847
No. of Pages:
240
Publisher:
ASME Press
Publication date:
2009
eBook Chapter
3 Members in Bending
Page Count:
25
-
Published:2009
Citation
Jawad, MH, & Jetter, RI. "Members in Bending." Design & Analysis of ASME Boiler and Pressure Vessel Components in the Creep Range. Ed. Jawad, MH, & Jetter, RI. ASME Press, 2009.
Download citation file:
Many components in pressurized equipment operating in the creep range consist of beams and flat plates in bending. These include piping components, internal catalyst supports, nozzle covers, and tubesheets. In this chapter, the characteristics of beams in bending are studied first, followed by an evaluation of flat circular plates in bending.
The characteristics of beams in bending operating in the creep range have been studied by many engineers and researchers. Theoretically, the analysis is based on the following Norton's relationship correlating stress and strain rate in the creep regime as discussed in Chapters 1 and 2 and as given by where k = constant n = creep exponent, which is a function of material property and temperature dε∕dT = strain rate σ = stress
This equation, however, is impractical to use for most problems encountered by the engineer as discussed in Section 2.1. A simpler method, referred to as the stationary stress or the elastic analog method, is normally used to solve beam bending problems and is given by
3.1 Introduction
3.2 Bending of Beams
3.2.1 Rectangular Cross-Sections
3.2.2 Circular Cross-Sections
3.3 Shape Factors
3.3.1 Rectangular Cross-Sections
3.3.2 Circular Cross-Sections
3.4 Deflection of Beams
3.5 Piping Analysis — ANSI 31.1 and 31.3
3.5.1 Introduction
3.5.2 Design Categories and Allowable Stresses
3.5.3 Creep Effects
3.6 Stress Analysis
3.6.1 Commercial Programs
3.7 Reference Stress Method
3.8 Circular Plates
This content is only available via PDF.
You do not currently have access to this chapter.
Email alerts
Related Chapters
Structural Members in Bending
Analysis of ASME Boiler, Pressure Vessel, and Nuclear Components in the Creep Range
Axially Loaded Members
Design & Analysis of ASME Boiler and Pressure Vessel Components in the Creep Range
Personnel and Requirements
Heat Exchanger Engineering Techniques
Part 2, Section II—Materials and Specifications
Companion Guide to the ASME Boiler and Pressure Vessel Code, Volume 1, Third Edition
Related Articles
Numerical Simulation of Creep-Induced Buckling of Thin-Walled Pipe Liners
J. Pressure Vessel Technol (August,2001)
Assessment of Steels for Nuclear Reactor Pressure Vessels
J. Eng. Power (October,1964)
Development and Application of a Complete Multijet Common-Rail Injection-System Mathematical Model for Hydrodynamic Analysis and Diagnostics
J. Eng. Gas Turbines Power (November,2008)