Skip to Main Content

Decommissioning Handbook

Editor
Anibal L. Taboas
Anibal L. Taboas
Search for other works by this author on:
A. Alan Moghissi
A. Alan Moghissi
Search for other works by this author on:
Thomas S. LaGuardia
Thomas S. LaGuardia
Search for other works by this author on:
ISBN-10:
0791802248
No. of Pages:
476
Publisher:
ASME Press
Publication date:
2004

Decontamination is the removal of material from areas where it is not wanted. This chapter will deal with the removal of radionuclides, but the same or similar technology could be used for the removal of hazardous chemical material. The technology is similar to the cleaning of dirt, oil. or corrosion products except that radionuclides are associated with the material, Both cleaning and decontamination require similar technologies, methods, equipment, and procedures but the degree of cleaning may be different. The degree of cleaning is defined by certain cleanliness standards. Decontamination is based on cleanliness standards that typically revolve around a personal dose rate or contamination level associated with the component or surface being cleaned. For disposal of the cleaning material, the chemical composition of both the waste and the radionuclide content must be understood. The disposal method and packaging will depend on all of these items.

Decontamination is used to reduce the dose that workers may receive from a component or surface, to reduce the potential for airborne radionuclides, or to reduce the associated disposal cost. Some decontamination can allow for the reuse or recycle of the material, although this approach is currently less common. An example of reuse of material is the melting of slightly contaminated steels to be manufactured into shield blocks for a particle cyclotron. The shield blocks keep natural radiation sources from interfering with the acceleration of particles. Many tons of materials have been recycled for use in nonradioactive environments. In order to accomplish a use for “free-release,” the material must not only be cleaned but also surveyed and found to be below the releasable level of the facility. The facilities that perform “free-release” are licensed by the federal government or the state in which they operate. The license and regulations specify the release limits of the facility.

This document is meant as an introduction to decontamination, both chemical and mechanical, with references to direct the reader to greater detail. The listing of any commercial companies should not be construed as a recommendation for the offerings of products or services.

This content is only available via PDF.
Close Modal
This Feature Is Available To Subscribers Only

Sign In or Create an Account

Close Modal
Close Modal