Abstract
Static indentation-flexure and low-velocity impact tests were performed on quasi-isotropic and cross-ply graphite/epoxy composite laminates. The load-deflection relations in static tests and impact force history in impact tests were recorded. The damage was assessed by using ultrasonic C-scanning and photo-micrographic techniques. Some features of the static behavior were explained by simple analytical models. A good correlation existed between the load-deflection curves for static and impact loading. It was found that results from a few static indentation-flexure tests can be used to predict the impact force history and delamination radius in composite laminates due to low-velocity impact.
Issue Section:
Research Papers
References
1.
Sankar
, B. V.
,Ku
, C.
, and Nguyen
, P. T.
, “Nondimensional Impact Models for Composite Laminates
,” in Proceedings of the 5th Technical Conference
, American Society for Composites, Technomic Publishing Co.
, Lancaster, PA
, 1990
, pp. 600
-610
.2.
Kwon
, Y. S.
and Sankar
, B. V.
, “Indentation-Flexure Damage in Graphite/Epoxy Laminates
,” NASA CR 187624, 1991
.3.
Sjöblom
, P. O.
,Hartness
, J. T.
, and Cordell
, T. M.
, “On Low-Velocity Impact Testing of Composite Materials
,” Journal of Composite Materials
0021-9983, Vol. 22
, 1988
, pp. 30
-52
.4.
Sankar
, B. V.
, “Contact Law for Transversely Isotropic Materials
,” in Proceedings of the 26th SDM Conference
, AIAA/ASME/ASCE/AHS
, Orlando, FL
, 1985
, pp. 516
-521
.5.
Bostaph
, G. M.
and Elber
, W.
, “Static Indentation Tests on Composite Plates for Impact Susceptibility Evaluation
,” in Proceedings of the Army Symposium on Solid Mechanics
, AMMRC MS 82-4, U.S. Army, 09
1982
, pp. 288
-317
.6.
Elber
, W.
, “Failure Mechanics in Low-Velocity Impacts on Thin Composite Plates
,” NASA Technical Paper
2152, 1983
.7.
Dost
, E. F.
,Ilcewicz
, L. B.
, and Gosse
, J. H.
, “Sublaminate Stability Based Modeling of Impact-Damaged Composite Laminates
,” in Proceedings of the 3rd Technical Conference
, American Society for Composites
, Seattle, WA
, 09
1988
, pp. 354
-363
.8.
Timoshenko
, S.
and Woinowsky-Krieger
, S.
, Theory of Plates and Shells
, McGraw-Hill
, New York
, 1959
.9.
Pinheiro
, M. A. S.
, “Finite Elements for Free Edge Delaminations and Delaminated Anisotropic Beams
” Ph.D dissertation, University of Florida
, Gainesville, FL, 1991
.
This content is only available via PDF.
All rights reserved. This material may not be reproduced or copied, in whole or in part, in any printed, mechanical, electronic, film, or other distribution and storage media, without the written consent of ASTM International.
You do not currently have access to this content.
