Optimization of cryosurgical procedures on deep tissues such as liver requires an increased understanding of the fundamental mechanisms of ice formation and water transport in tissues during freezing. In order to further investigate and quantify the amount of water transport that occurs during freezing in tissue, this study reports quantitative and dynamic experimental data and theoretical modeling of rat liver freezing under controlled conditions. The rat liver was frozen by one of four methods of cooling: Method 1—ultrarapid “slam cooling” (≥ 1000° C/min) for control samples; Method 2—equilibrium freezing achieved by equilibrating tissue at different subzero temperatures (−4, −6, −8, −10°C); Method 3°-two-step freezing, which involves cooling at 5°C/min. to −4, −6, −8, −10 or −20°C followed immediately by slam cooling; or Method 4—constant and controlled freezing at rates from 5–400°C/min. on a directional cooling stage. After freezing, the tissue was freeze substituted, embedded in resin, sectioned, stained, and imaged under a light microscope fitted with a digitizing system. Image analysis techniques were then used to determine the relative cellular to extracellular volumes of the tissue. The osmotically inactive cell volume was determined to be 0.35 by constructing a Boyle van’t Hoff plot using cellular volumes from Method 2. The dynamic volume of the rat liver cells during cooling was obtained using cellular volumes from Method 3 (two-step freezing at 5°C/min). A nonlinear regression fit of a Krogh cylinder model to the volumetric shrinkage data in Method 3 yielded the biophysical parameters of water transport in rat liver tissue of: Lpg = 3.1 X 10−13 m3/Ns (1.86 μ/min-atm) and ELP = 290 kJ/mole (69.3 kcal/mole), with chi-squared variance of 0.00124. These parameters were then incorporated into the Krogh cylinder model and used to simulate water transport in rat liver tissue during constant cooling at rates between 5–100°C/min. Reasonable agreement between these simulations and the constant cooling rate freezing experiments in Method 4 were obtained. The model predicts that the water transport ceases at a relatively high subzero temperature (−10°C), such that the amount of intracellular ice forming in the tissue cells rises from almost none (=extensive dehydration and vascular expansion) at ≤5°C/min to over 88 percent of the original cellular water at ≥50°C/min. The theoretical simulations based on these experimental methods may be of use in visualizing and predicting freezing response, and thus can assist in the planning and implementing of cryosurgical protocols.
Skip Nav Destination
Article navigation
August 1997
Technical Papers
Measurement and Simulation of Water Transport During Freezing in Mammalian Liver Tissue
P. V. Pazhayannur,
P. V. Pazhayannur
Department of Mechanical Engineering, University of Minnesota, Minneapolis, MN 55455
Search for other works by this author on:
J. C. Bischof
J. C. Bischof
Department of Mechanical Engineering, University of Minnesota, Minneapolis, MN 55455
Search for other works by this author on:
P. V. Pazhayannur
Department of Mechanical Engineering, University of Minnesota, Minneapolis, MN 55455
J. C. Bischof
Department of Mechanical Engineering, University of Minnesota, Minneapolis, MN 55455
J Biomech Eng. Aug 1997, 119(3): 269-277 (9 pages)
Published Online: August 1, 1997
Article history
Received:
September 14, 1995
Revised:
May 8, 1996
Online:
October 30, 2007
Citation
Pazhayannur, P. V., and Bischof, J. C. (August 1, 1997). "Measurement and Simulation of Water Transport During Freezing in Mammalian Liver Tissue." ASME. J Biomech Eng. August 1997; 119(3): 269–277. https://doi.org/10.1115/1.2796091
Download citation file:
Get Email Alerts
Related Articles
Effect of Microscale Mass Transport and Phase Change on Numerical Prediction of Freezing in Biological Tissues
J. Heat Transfer (April,2002)
Measurement of Water Transport During Freezing in Mammalian Liver Tissue: Part II—The Use of Differential Scanning Calorimetry
J Biomech Eng (October,1998)
The Effect of Dimethylsulfoxide on the Water Transport Response of Rat Hepatocytes During Freezing
J Biomech Eng (October,1998)
Predictive Modeling and Experimental Verification of Temperature and Concentration in Rapid Freeze Prototyping With Support Material
J. Manuf. Sci. Eng (August,2009)
Related Proceedings Papers
Related Chapters
Simulation and Optimization of Injection Process for LCD Cover
Proceedings of the 2010 International Conference on Mechanical, Industrial, and Manufacturing Technologies (MIMT 2010)
Industrially-Relevant Multiscale Modeling of Hydrogen Assisted Degradation
International Hydrogen Conference (IHC 2012): Hydrogen-Materials Interactions
Breathing and Living Walls
Advanced Energy Efficient Building Envelope Systems