The equatorial region of the canine left ventricle was modeled as a thick-walled cylinder consisting of an incompressible hyperelastic material with homogeneous exponential properties. The anisotropic properties of the passive myocardium were assumed to be locally transversely isotropic with respect to a fiber axis whose orientation varied linearly across the wall. Simultaneous inflation, extension, and torsion were applied to the cylinder to produce epicardial strains that were measured previously in the potassium-arrested dog heart. Residual stress in the unloaded state was included by considering the stress-free configuration to be a warped cylindrical arc. In the special case of isotropic material properties, torsion and residual stress both significantly reduced the high circumferential stress peaks predicted at the endocardium by previous models. However, a resultant axial force and moment were necessary to cause the observed epicardial deformations. Therefore, the anisotropic material parameters were found that minimized these resultants and allowed the prescribed displacements to occur subject to the known ventricular pressure loads. The global minimum solution of this parameter optimization problem indicated that the stiffness of passive myocardium (defined for a 20 percent equibiaxial extension) would be 2.4 to 6.6 times greater in the fiber direction than in the transverse plane for a broad range of assumed fiber angle distributions and residual stresses. This agrees with the results of biaxial tissue testing. The predicted transmural distributions of fiber stress were relatively flat with slight peaks in the subepicardium, and the fiber strain profiles agreed closely with experimentally observed sarcomere length distributions. The results indicate that torsion, residual stress and material anisotropy associated with the fiber architecture all can act to reduce endocardial stress gradients in the passive left ventricle.
Skip Nav Destination
Article navigation
February 1991
Research Papers
Passive Material Properties of Intact Ventricular Myocardium Determined From a Cylindrical Model
J. M. Guccione,
J. M. Guccione
Department of Applied Mechanics and Engineering Sciences (Bioengineering), The University of California, San Diego, La Jolla, Calif. 92093-0412
Search for other works by this author on:
A. D. McCulloch,
A. D. McCulloch
Department of Applied Mechanics and Engineering Sciences (Bioengineering), The University of California, San Diego, La Jolla, Calif. 92093-0412
Search for other works by this author on:
L. K. Waldman
L. K. Waldman
Department of Medicine (Cardiology), The University of California, San Diego, La Jolla, Calif. 92093-0412
Search for other works by this author on:
J. M. Guccione
Department of Applied Mechanics and Engineering Sciences (Bioengineering), The University of California, San Diego, La Jolla, Calif. 92093-0412
A. D. McCulloch
Department of Applied Mechanics and Engineering Sciences (Bioengineering), The University of California, San Diego, La Jolla, Calif. 92093-0412
L. K. Waldman
Department of Medicine (Cardiology), The University of California, San Diego, La Jolla, Calif. 92093-0412
J Biomech Eng. Feb 1991, 113(1): 42-55 (14 pages)
Published Online: February 1, 1991
Article history
Received:
May 24, 1989
Revised:
October 1, 1990
Online:
March 17, 2008
Citation
Guccione, J. M., McCulloch, A. D., and Waldman, L. K. (February 1, 1991). "Passive Material Properties of Intact Ventricular Myocardium Determined From a Cylindrical Model." ASME. J Biomech Eng. February 1991; 113(1): 42–55. https://doi.org/10.1115/1.2894084
Download citation file:
Get Email Alerts
Improvement in Active Cell Proliferation Area at Higher Permeability With Novel TPMS Lattice Structure
J Biomech Eng (November 2024)
Modeling Fatigue Failure of Cartilage and Fibrous Biological Tissues Using Constrained Reactive Mixture Theory
J Biomech Eng (December 2024)
A Numerical Study of Crack Penetration and Deflection at the Interface Between Peritubular and Intertubular Dentin
J Biomech Eng (December 2024)
Related Articles
Biaxial Mechanical Properties of Passive Right Ventricular Free Wall Myocardium
J Biomech Eng (May,1993)
Relative Contributions of Matrix and Myocytes to Biaxial Mechanics of the Right Ventricle in Pulmonary Arterial Hypertension
J Biomech Eng (September,2019)
Structural Finite Deformation Model of the Left Ventricle During Diastole and Systole
J Biomech Eng (November,1989)
On Modeling Morphogenesis of the Looping Heart Following Mechanical Perturbations
J Biomech Eng (December,2008)
Related Proceedings Papers
Related Chapters
Supporting Systems/Foundations
Handbook on Stiffness & Damping in Mechanical Design
Chapter 1 | Background
Guidelines for the Selection and Training of Sensory Panel Members
Basic Concepts
Design & Analysis of ASME Boiler and Pressure Vessel Components in the Creep Range