As modern helmets have become quite capable of defeating the penetration capabilities of ballistic threats, Soldiers may experience head injuries due to blunt trauma caused by helmet back face deformation (BFD). Possible resulting injuries include skull fracture, hematoma, concussion, contusion, diffuse axonal injury, etc. Some of these injuries have been associated with traumatic brain injury. In order to assess potential injury mechanisms prior to fielding new helmets, we have developed a means to experimentally replicate and measure helmet BFD that can be correlated to injury criteria. In this study, helmet performance test methodology is developed using a digital image correlation (DIC) technique. DIC provides the capability to measure dynamic displacements, thereby providing the ability to calculate deformation, velocity, and acceleration rates. We have shown that digital image correlation is an experimentation technique that accurately captures BFD area and rate of deformation for impacts against combat helmets. We used the DIC data to calculate a new metric; the available energy that could potentially impact a Soldier’s head. Our study shows that DIC data upholds the hypothesis that helmet BFD mechanically loads the skull similar to a direct impact from a less-than-lethal projectile or blunt object impact. The available energy obtained from DIC measurements was used to calculate the blunt criterion (BC) for helmet standoff distances of 12.7 mm (0.5 in) and 19.1 mm (0.75 in), which in turn can provide a prediction of the probability of abbreviated injury scale (AIS) levels and, in particular, skull fracture. DIC can be used to provide dynamic helmet performance data that will allow increased understanding of BFD and quantitative assessment and validation of helmet performance results. Knowledge of the conditions leading to head trauma obtained through DIC experimentation should enable the selection of new energy-absorbing materials for helmets; thus, allowing new helmet design candidate performances to be objectively evaluated. Test data and characterization of helmet response could then be used to achieve improved warfighter survivability.
Skip Nav Destination
e-mail: dixie.hisley@us.army.mil
e-mail: james.gurganus@us.army.mil
e-mail: andrew.drysdale@us.army.mil
Article navigation
September 2011
Research Papers
Experimental Methodology Using Digital Image Correlation to Assess Ballistic Helmet Blunt Trauma
Dixie M. Hisley,
Dixie M. Hisley
General Engineer Army Research Laboratory,
e-mail: dixie.hisley@us.army.mil
System Engineering & Experimentation Branch
, Aberdeen Proving Ground, MD 21005
Search for other works by this author on:
James C. Gurganus,
James C. Gurganus
Mechanical Engineer Army Research Laboratory, System Engineering & Experimentation Branch, Aberdeen Proving Ground, MD 21005
e-mail: james.gurganus@us.army.mil
Search for other works by this author on:
Andrew W. Drysdale
Andrew W. Drysdale
Mechanical Engineer Army Research Laboratory, System Engineering & Experimentation Branch, Aberdeen Proving Ground, MD 21005
e-mail: andrew.drysdale@us.army.mil
Search for other works by this author on:
Dixie M. Hisley
General Engineer Army Research Laboratory,
System Engineering & Experimentation Branch
, Aberdeen Proving Ground, MD 21005e-mail: dixie.hisley@us.army.mil
James C. Gurganus
Mechanical Engineer Army Research Laboratory, System Engineering & Experimentation Branch, Aberdeen Proving Ground, MD 21005
e-mail: james.gurganus@us.army.mil
Andrew W. Drysdale
Mechanical Engineer Army Research Laboratory, System Engineering & Experimentation Branch, Aberdeen Proving Ground, MD 21005
e-mail: andrew.drysdale@us.army.mil
J. Appl. Mech. Sep 2011, 78(5): 051022 (7 pages)
Published Online: August 8, 2011
Article history
Received:
November 23, 2010
Revised:
May 23, 2011
Published:
August 5, 2011
Online:
August 8, 2011
Citation
Hisley, D. M., Gurganus, J. C., and Drysdale, A. W. (August 8, 2011). "Experimental Methodology Using Digital Image Correlation to Assess Ballistic Helmet Blunt Trauma." ASME. J. Appl. Mech. September 2011; 78(5): 051022. https://doi.org/10.1115/1.4004332
Download citation file:
Get Email Alerts
Sound Mitigation by Metamaterials With Low-Transmission Flat Band
J. Appl. Mech (January 2025)
Deformation-Dependent Effective Vascular Permeability of a Biological Tissue Containing Parallel Microvessels
J. Appl. Mech (January 2025)
Mechanics of a Tunable Bistable Metamaterial With Shape Memory Polymer
J. Appl. Mech (January 2025)
Related Articles
Why Impacted Yarns Break at Lower Speed Than Classical Theory Predicts
J. Appl. Mech (September,2011)
Quantification of Behind Shield Blunt Impacts Using a Modified Upper Extremity Anthropomorphic Test Device
J Biomech Eng (September,2022)
Related Chapters
. . … and the Heyday to Come
Air Engines: The History, Science, and Reality of the Perfect Engine
Safety
Engineering the Everyday and the Extraordinary: Milestones in Innovation
Introduction and Definitions
Handbook on Stiffness & Damping in Mechanical Design