This paper presents modeling and testing results for membrane wrinkling control using material’s property changes produced by a 1st order phase transformation. ANSYS® is utilized to determine the membrane’s length and width as well as thickness to produce wrinkling in a test sample. Test results conducted on a NiTi 20.9mm×10.8mm×5.5μm sample produce wrinkling at approximately 1% strain, which is the critical strain (εcr). Using the phase transformation properties and corresponding stiffness change, we demonstrated that wrinkling control (i.e. turning it on and off) is possible simply by changing the temperature through the phase transformation. The maximum amplitude of the wrinkles was 46.5 ± 5.4μm and the wavelength was 2.05 ± 0.40mm.
Volume Subject Area:
Active Materials, Mechanics and Behavior
This content is only available via PDF.
Copyright © 2009
by ASME
You do not currently have access to this content.