In this work the significance of residual stresses for ductile fracture was investigated. The treatment of residual stresses as expressed in fracture assessment procedures such as the R6 method is believed to be very conservative for ductile materials, when fracture occurs at high primary loads. Earlier numerical studies have reinforced this belief. Tests on notched 3PB specimens with and without residual stresses were conducted on two ferritic steels. The residual stresses were introduced by applying a compressive pre-load on notched specimens. The tests were designed to achieve crack initiation at load levels around the limit load. The crack growth in the tests was measured by a compliance method and by colour marking of the crack surface. The crack-tip driving force J was evaluated numerically for specimens with and without residual stresses. The experimental results show that the residual stresses clearly contribute to J at low primary loads. However, this contribution diminishes as the primary loads increase. The experimental results were also compared with results evaluated using the R6 procedure. These comparisons revealed an overly high conservativeness in R6 for cases with residual stresses compared to the conservativeness for cases without residual stresses.
- Pressure Vessels and Piping Division
Evaluation of the Influence of Residual Stresses on Ductile Fracture
- Views Icon Views
- Share Icon Share
- Search Site
Bolinder, T, Sattari-Far, I, & Faleskog, J. "Evaluation of the Influence of Residual Stresses on Ductile Fracture." Proceedings of the ASME 2011 Pressure Vessels and Piping Conference. Volume 6: Materials and Fabrication, Parts A and B. Baltimore, Maryland, USA. July 17–21, 2011. pp. 347-356. ASME. https://doi.org/10.1115/PVP2011-58080
Download citation file: