Abstract
After constructing a scale model of planned changes to a power plant exhaust system, tests were performed to measure pressure losses in the transition, silencer, and stack. A dimension of 0.30 m (1.0 ft) for the scale model corresponded to 3.7 m (12.0 ft) at full scale. To the extent possible, the scale model tests exhibited geometric similarity with the actual power plant. Total pressure loss coefficients varied between 2.122, 1.969, and 1.932, for three separate scale model configurations that were considered. A combination of turning vanes and splitter vanes in the five-gore elbow, coupled with the use of turning vanes in the rectangular elbow yielded the lowest total pressure loss. Although Reynolds number similarity between the scale model experiments and the actual power plant was not attained, Reynolds number independence was achieved in the tests. The results from this study was applied to model pressure loss in the actual power plant. The scale model testing revealed that utilization of the exhaust ducting design designated as Case A would yield a sufficiently low pressure loss that it would not degrade the performance of the combustion turbine in the power plant to be repaired. Therefore it was selected for inclusion in the retro-fitting of the power plant to facilitate its being quickly brought back on-line.