Cooling, Heating, and Power (CHP) energy systems provide higher fuel efficiency than conventional systems, resulting in reduced emissions and other environmental benefits. Until recently the focus of CHP system development has been primarily on medium-scale commercial applications in a limited number of market segments where clear value propositions lead to short term payback. Small-scale integrated CHP systems that show promise of achieving economic viability through significant improvements in fuel utilization have received increased attention lately. In this paper the economic potential is quantified for small-scale (micro-grid) integrated CHP systems suitable for groups of buildings with aggregate electric loads in the 15 kW–120 kW range. Technologies are evaluated for community building groups (CBGs) consisting of aggregation of pure residential entities and combined residential and light commercial entities. Emphasis is on determination of the minimum load size (i.e. the smallest electric and thermal load for a given CBG that is supplied with electric, heating, cooling power from a CHP) for which a micro-grid CHP system is both technically and economically viable. In this paper, the operation of the CHP system is parallel with the public utility grid at all times, i.e. the grid is interconnected. Evaluations of CHP technology options using simulation studies in a “three-dimensional” space (CHP technology option, CBG load aggregation, and geographical location in the USA) were evaluated based on comparisons of net present value (NPV). The simulations indicated that as electric load increases, the viability of the CHP system (independent of the system’s size) becomes more favorable. Exceeding a system runtime (utilization) of 70% was shown to pass the break-even line in the NPV analysis. Finally, geographic location was found to have a relatively weak effect on the reported trends. These results suggest that micro grid CHP systems have the potential to be economically viable with relative independence of geographic location if adequately sized to match the load requirements.
Skip Nav Destination
ASME 2005 Power Conference
April 5–7, 2005
Chicago, Illinois, USA
Conference Sponsors:
- Power Division
ISBN:
0-7918-4182-0
PROCEEDINGS PAPER
Microgrid Viability for Small-Scale Cooling, Heating, and Power
Lubomir A. Ribarov,
Lubomir A. Ribarov
United Technologies Research Center, East Hartford, CT
Search for other works by this author on:
David S. Liscinsky
David S. Liscinsky
United Technologies Research Center, East Hartford, CT
Search for other works by this author on:
Lubomir A. Ribarov
United Technologies Research Center, East Hartford, CT
David S. Liscinsky
United Technologies Research Center, East Hartford, CT
Paper No:
PWR2005-50045, pp. 871-877; 7 pages
Published Online:
October 27, 2008
Citation
Ribarov, LA, & Liscinsky, DS. "Microgrid Viability for Small-Scale Cooling, Heating, and Power." Proceedings of the ASME 2005 Power Conference. ASME 2005 Power Conference. Chicago, Illinois, USA. April 5–7, 2005. pp. 871-877. ASME. https://doi.org/10.1115/PWR2005-50045
Download citation file:
9
Views
Related Proceedings Papers
Related Articles
Microgrid Viability for Small-Scale Cooling, Heating, and Power
J. Energy Resour. Technol (March,2007)
Combined Heat and Power Plant and District Heating and Cooling Network: A Test-Case in Italy With Integration of Renewable Energy
J. Sol. Energy Eng (October,2018)
Guidance on Evaluating the Performance of Multigeneration Systems Based on Energetic and Exergetic Criteria
J. Sol. Energy Eng (December,2023)
Related Chapters
Introduction
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration
Risk Mitigation for Renewable and Deispersed Generation by the Harmonized Grouping (PSAM-0310)
Proceedings of the Eighth International Conference on Probabilistic Safety Assessment & Management (PSAM)
Performance Evaluation of Wireless LAN for Control, Protection, and Monitoring of a Microgrid
International Conference on Software Technology and Engineering, 3rd (ICSTE 2011)