... Abstract ECO-CLIP has developed a novel recycled 40wt% short CF/LMPAEK material from factory scrap that has been used to manufacture aircraft structural parts using injection molding (IM), the conventional manufacturing process, and fussed granulated fabrication (FGF) as an alternative one...

... that reflects the success of filling in a polymer injection molding process. Geometry of the part, rheological properties of the polymer and process parameters, such as injection pressure and temperature, are involved on the value of this parameter and therefore on the viability of a certain configuration...

... with 0.1–5 wt.% of MWCNTs were prepared by injection molding. Then, the HDPE/MWCNT composite waste was mechanically recycled and consecutively reprocessed by injection molding. The experimental results show that, after the first mechanical recycling and reprocessing cycle, the thermal, rheological...

... Predicting friction forces present between part and mold surfaces in injection molding of thermoplastics is considered an important step in the design of the ejector system. However, this requires calculating the coefficient of friction at the contact surfaces, which is usually a complex task...

... reference sustainability characterization methodologies for unit manufacturing processes, in this paper we focus on injection molding with energy as the sustainability indicator. We present a science-based guideline to characterize energy consumption for a part manufactured using the injection molding...