The common challenge found in cases of high elasticity or high strength or both property materials after forming is springback. The part unloaded after forming tends to recover elastically and the displacement due to elastic recovery is called springback. In this paper, the 3D channels with large length were deformed numerically and parametric study on the wall springback at different section was predicted. For this purpose tailor welded blank was considered. The geometric change along the long axis was also discussed. In addition the effect of parameters on wall springback was also analyzed. The new division factor was included to normalize the springback based on thickness and strength. It was found that the strength ratio and die and punch radius were the top influencing factor for front edge and weld line springback while thickness ratio was the most affecting parameter for the back edge springback.
Skip Nav Destination
ASME 2016 11th International Manufacturing Science and Engineering Conference
June 27–July 1, 2016
Blacksburg, Virginia, USA
Conference Sponsors:
- Manufacturing Engineering Division
ISBN:
978-0-7918-4989-7
PROCEEDINGS PAPER
Parametric Study on Wall Springback in Tailor Welded Long Channels Available to Purchase
Chetan P. Nikhare
Chetan P. Nikhare
Penn State Behrend, Erie, PA
Search for other works by this author on:
Chetan P. Nikhare
Penn State Behrend, Erie, PA
Paper No:
MSEC2016-8649, V001T02A062; 10 pages
Published Online:
September 27, 2016
Citation
Nikhare, CP. "Parametric Study on Wall Springback in Tailor Welded Long Channels." Proceedings of the ASME 2016 11th International Manufacturing Science and Engineering Conference. Volume 1: Processing. Blacksburg, Virginia, USA. June 27–July 1, 2016. V001T02A062. ASME. https://doi.org/10.1115/MSEC2016-8649
Download citation file:
11
Views
Related Proceedings Papers
Related Articles
Exact Solutions for Flexoelectric Response in Nanostructures
J. Appl. Mech (September,2014)
A Semi-Infinite Strip Pressed Against an Elastic Half-Plane With Frictional Slip
J. Appl. Mech (June,2018)
Homogenization and Path Independence of the J -Integral in Heterogeneous Materials
J. Appl. Mech (October,2016)
Related Chapters
Study on Weld-Line Movement of TWBs with Different Thickness in Hydro-Forming Deep Drawing of Square Cup
International Conference on Mechanical Engineering and Technology (ICMET-London 2011)
Preparing Your Presentation Notes
Technical Presentation Workbook: Winning Strategies for Effective Public Speaking, Third Edition
Farsi/Arabic Document Image Retrieval Through Sub-Letter Shape Coding
International Conference on Computer Technology and Development, 3rd (ICCTD 2011)