The tool wear is one of common failure modes under the higher speed operating conditions in the deep-hole drilling. Since the tool wear is directly related to the tool geometry and the cutting forces, it is reasonable to utilize the cutting force modeling to optimize the tool geometric parameters. Two typical modeling methods were utilized for the cutting force modeling of drilling processes: empirical model and geometric analytical model. Since the value and distribution of cutting force are influenced by the tool geometry, the optimization of the geometric parameters is deduced in the geometric analytical model of the deep-hole drilling processes in this paper. As a result, a tool design was derived based on the optimization of these geometric parameters.
Skip Nav Destination
ASME 2014 International Manufacturing Science and Engineering Conference collocated with the JSME 2014 International Conference on Materials and Processing and the 42nd North American Manufacturing Research Conference
June 9–13, 2014
Detroit, Michigan, USA
Conference Sponsors:
- Manufacturing Engineering Division
ISBN:
978-0-7918-4581-3
PROCEEDINGS PAPER
Geometric Parameter Optimization in Cutting Force Model for Deep-Hole Drilling
Yueen Li,
Yueen Li
Shandong Jianzhu University, Jinan, Shandong, China
Purdue University, West Lafayette, IN
Search for other works by this author on:
Haiyan H. Zhang,
Haiyan H. Zhang
Purdue University, West Lafayette, IN
Search for other works by this author on:
Cong Liao
Cong Liao
Wuhan University of Technology, Wuhan, Hubei, China
Purdue University, West Lafayette, IN
Search for other works by this author on:
Yueen Li
Shandong Jianzhu University, Jinan, Shandong, China
Purdue University, West Lafayette, IN
Haiyan H. Zhang
Purdue University, West Lafayette, IN
Cong Liao
Wuhan University of Technology, Wuhan, Hubei, China
Purdue University, West Lafayette, IN
Paper No:
MSEC2014-4221, V002T02A004; 7 pages
Published Online:
October 3, 2014
Citation
Li, Y, Zhang, HH, & Liao, C. "Geometric Parameter Optimization in Cutting Force Model for Deep-Hole Drilling." Proceedings of the ASME 2014 International Manufacturing Science and Engineering Conference collocated with the JSME 2014 International Conference on Materials and Processing and the 42nd North American Manufacturing Research Conference. Volume 2: Processing. Detroit, Michigan, USA. June 9–13, 2014. V002T02A004. ASME. https://doi.org/10.1115/MSEC2014-4221
Download citation file:
14
Views
Related Proceedings Papers
Related Articles
Modeling of Forces for Drills With Chip-Breaking Grooves
J. Manuf. Sci. Eng (August,2004)
Modeling of the Thread Milling Operation in a Combined Thread/Drilling Operation: Thrilling
J. Manuf. Sci. Eng (February,2010)
Wear Analysis and Tool Life Modeling in Micro Drilling of Inconel 718 Superalloy
J. Tribol (October,2022)
Related Chapters
Study on Screw Drill Wear When Drilling Low Carbon Stainless Steel and Accompanying Phenomena in the Cutting Zone
International Conference on Instrumentation, Measurement, Circuits and Systems (ICIMCS 2011)
Cultural Impediments to Practical Modeling of Wear Rates
Tribological Modeling for Mechanical Designers
Layout
Fabrication of Metallic Pressure Vessels